Indesit BDE 76435 9WS EE Beknopte handleiding - Pagina 2

Blader online of download pdf Beknopte handleiding voor {categorie_naam} Indesit BDE 76435 9WS EE. Indesit BDE 76435 9WS EE 4 pagina's.

Pagina afdrukken

WASH CYCLES

Follow the instructions on the symbols of the garment's wash

care label. The value indicated in the symbol is the maximum

recommended temperature for washing the garment.

Cotton: suitable for washing towels, underwear, table cloths,

etc. made of resistant linen and cotton that are moderately to heavily

soiled.

Synthetics: specific for synthetic items. If the dirt is difficult to remove,

the temperature can be increased up to 60° and powder detergent can be

used too.

Mixed: for washing lightly to normally soiled resilient garments in cotton,

linen, synthetic fibres and mixed fibres.

Eco 40-60: for washing normally soiled cotton garments declared to be

washable at 40 °C or 60 °C, together in the same cycle. This is the standard

cotton programme and the most efficient in terms of water and energy

consumption.

White: suitable for resistant linen and cotton that are heavily soiled.

Delicates: use programme 6 to wash very delicate garments. It is

advisable to turn the garments inside out before washing them. For best

results, use liquid detergent on delicate garments.

When selecting an exclusively time-based drying function, a drying cycle is

performed at the end of the wash cycle that is particularly delicate, thanks

to light handling and appropriate temperature control of the water jet.

The recommended durations are:

1 kg of synthetic garments --> 150 min

1 kg of synthetic and cotton garments --> 180 min

1 kg of cotton garments --> 180 min

The degree of dryness depends on the load and fabric composition.

Colours: for washing coloured cotton garments. This programme is

optimised to keep colours bright even after repeated

Dark: use programme 8 to wash dark-coloured garments. This

programme is designed to maintain dark colours over time. We

recommend using a liquid detergent for the best results when washing

dark-coloured garments.

When you select the drying function, at the end of the washing cycle the

machine will automatically perform a delicate drying cycle that preserves the

colours of the garments. The display will show the level "

Anti-odour: use programme 9 for washing garments with bad odours

(e.g. smoke, sweat, fried food). The programme is designed to remove bad

odours while preserving the fabric fibres. Synthetics fabrics or mixed

loads should be washed at 40°.

20°C: for washing lightly soiled cotton garments, at a temperature of 20 °C.

Wool - Wool Care : The wool wash cycle of this machine has been

approved by The Woolmark Company for the washing of machine

washable wool products provided that the products are washed

according to the instructions on the garment label and those issued by

the manufacturer of this washing machine. The Woolmark symbol is a

Certification mark in many countries. M2227.

Rapid 30': this programme is designed to wash lightly soiled garments at

30° (excluding wool and silk) with a 4.5 kg maximum load in a short time:

it only lasts 30 minutes and allows for saving time and

Wash&Dry 45': select programme 13 for washing and drying lightly

soiled garments (Cotton and Synthetic) in a short time. This cycle may be

used to wash and dry a laundry load of up to 1 kg in just 45 minutes. To

achieve optimum results, use liquid detergent and pre-treat cuffs, collars

and stains.

AirFresh: ideal cycle to refresh garments and remove bad odours, in

particular smoke, from cotton and synthetic items in 30' (max. 1.5 kg)

without the washing phase.

Rinse + Spin: designed for rinsing and spinning.

Spin + Drain: designed to spin and drain the water.

DISPLAY

The display is useful when programming the machine and provides a lot

of information.

The duration of the available wash cycles and the remaining time of a

running cycle appear in section A; if the Delayed Start option has been

set, the countdown to the start of the selected cycle will appear.

Pressing the corresponding button allows you to view either the

maximum spin speed, temperature and drying time values attained by

the machine during the set wash cycle, or the values selected most

recently (if compatible with the set wash cycle).

The hourglass flashes while the machine processes the data on the basis

of the selected cycle. After a maximum of 10 minutes, the

steady lit and the final time remaining is displayed. The "hourglass" icon

will then switch off approximately 1 minute after the final time remaining

has been displayed.

The "washing phases" relative to the selected cycle and the "washing

phase" of the running cycle appear in section B:

Wash

Rinse

Spin/ Drain

Drying

When lit, the symbol

appeared on the display.

There are three levels in section C relative to the washing options.

Section D includes the icons related to the three different drying levels as

well as the icon

DOOR LOCKED INDICATOR

When lit, the symbol indicates that the door is locked. To prevent any

damage, wait until the symbol turns off before opening the door.

To open the door while a cycle is in progress, press the START/PAUSE

button

FIRST-TIME USE

Once the appliance has been installed, and before it is used for the first

time, run a wash cycle with detergent and no laundry, by setting the

"Auto-Clean" cycle.

DAILY USE

Prepare the laundry by following the suggestions appearing under the

washing.

"TIPS AND SUGGESTIONS" section.

Rapid programming

- Press the ON/OFF button

flash slowly green.

- Open the door. Load the laundry while making sure not to exceed the

maximum load quantity indicated in the cycle table.

- Pull out the detergent dispenser drawer and pour the detergent into the

". Max. load: 5 kg.

relevant compartments as described in "DETERGENT DISPENSER DRAWER"

section.

- Close the door.

STARTING CYCLE

Press the PUSH & GO button.

The machine will lock the door (

rotate; the door will be unlocked (

(

symbol on) as preparation phase of each washing cycle. The "Clicking"

noise is part of the door locking mechanism. Water will enter the drum

and start the washing phase once the door is locked.

Traditional programming

- Press the ON/OFF button

flash slowly green.

- Open the door. Load the laundry while making sure not to exceed the

maximum load quantity indicated in the Wash Cycle Table.

- Pull out the detergent dispenser drawer and pour the detergent into the

relevant compartments as described in "DETERGENT DISPENSER DRAWER"

section.

- Close the door.

- Use the WASH CYCLE selector knob to select the desired wash cycle: it

energy.

will be associated with a specific temperature and spin speed that can be

modified. The duration of the cycle will appear on the display.

- Modify the temperature and/or spin speed: the machine automatically

displays the maximum temperature and spin speed values set for the

selected cycle, or the most recently-used settings if they are compatible

with the selected cycle. Pressing the

temperature down to the cold wash "OFF" setting. Pressing the

gradually reduces the spin speed until it is completely excluded ("OFF"

setting). Pressing

- Select the desired options.

STARTING CYCLE

Press the START/PAUSE

The machine will lock the door (

rotate; the door will be unlocked (

(

symbol on) as preparation phase of each washing cycle. The "Clicking"

noise is part of the door locking mechanism. Water will enter the drum

and start the washing phase once the door is locked.

PAUSING A CYCLE

To pause the wash cycle, press the START/PAUSE

indicator light will flash amber. If the

opened. To start the wash cycle from the point at which it was

interrupted, press the START/PAUSE

OPENING THE DOOR, IF NECESSARY

Once a cycle starts, the

be opened. While a wash cycle is running, the door remains locked. To

open the door while a cycle is under way, for example, to add or remove

garments, press the START/PAUSE

indicator light will flash amber. If the

opened. Press the START/PAUSE

CHANGING A RUNNING WASH CYCLE

To change a wash cycle while it is in progress, pause the washer-dryer

using the START/PAUSE

amber), then select the desired cycle and press the START/PAUSE

button again.

indicates that the set "Delayed Start" value has

, which lights up when a timed drying option is set.

; if the

symbol is off, the door can be opened.

; the START/PAUSE indicator light

symbol on) and the drum will start to

symbol OFF) and then locked again

; the START/PAUSE indicator light

button gradually reduces the

these buttons again restores the maximum values.

button.

symbol on) and the drum will start to

symbol OFF) and then locked again

symbol is not lit, the door may be

button again.

symbol turns on to signal that the door cannot

button to pause the cycle; the

symbol is not lit, the door may be

button again to continue the cycle.

button (the relative indicator light will flash

icon remains

will

button

button again; the