Indesit IWME 146 Gebruiksaanwijzing - Pagina 16

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Indesit IWME 146. Indesit IWME 146 20 pagina's.

Pagina afdrukken

The machine is noisy.

The machine wont spin properly.

The machine leaks from the di-

spenser.

The machine leaks (other than

dispenser).

The indicator lights on the conso-

le are flashing rapidly.

The machine smells.

The machine door cannot be

opened.

Door Seal damaged at the bottom.

There is too much foam.

After completing the programme,

or before starting a programme,

the machine has turned itself off

(no lights).

General.

Remember, you will be charged for a service call for problems caused by incorrect installation,

as listed above.

Not emptying contents from pockets may cause pump or drain blockages, or may damage the machine.

Do not wash items which do not have a wash label, or wash items that are not intended as machine wa-

shable.

• There will always be some motor, pump and drum noise during spin.

• Out of Balance detected when attempting to go into a spin cycle - If this happens

the machine will continue to try to repeat the distribution of the load required

before the machine will go into higher spin speeds - This will increase

the programme time accordingly. This is a safety feature to prevent damage.

Out of Balance can be caused by washing a single heavy item (eg duvet,

quilt, etc). - Try the programme again using a different load.

• The dispenser drawer is blocked with detergent and requires cleaning.

• The water pressure is too high and requires turning down - turn down

the tap on the water supply pipe slightly and try again.

• The machine is tilting forwards - It must be level when in its final position.

• The fill hose is loose, check both the cabinet and tap ends.

• The fill hose is tight but still leaks, if so replace the rubber washers, or

the fill hose is missing the rubber washer.

• The drain hose is not fixed in properly.

• Switch off the machine and unplug it, wait for approximately 1 minute

and then switch it back on again If the problem persists contact the

Technical Assistance Service.

• The machine requires a service wash. Run a 90 degree wash cycle with

detergent and no laundry.

• The door will not open until the door lock indicator light goes out

shortly after the program has finished.

• The door seal has drainage holes at the bottom - This is normal.

• The detergent is not suitable for machine washing (it should display the

text 'for washing machines' or 'hand and machine wash' or the like).

• To comply with new energy saving regulations the machine is fitted with an

automatic standby system. Press 'ON/OFF' button for 3 seconds to activate

the machine, it can then either be switched off or a new programme selected.

• Your washing machine contains sensors that monitor progress during

the wash cycle (eg: Water Levels, Temperatures, Out of Balance

loads, Wash time/progress). Normally, if your machine successfully

completes the cycle, there is unlikely to be anything wrong!