Indesit DIF 14T1 Gebruiksaanwijzing - Pagina 15

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Indesit DIF 14T1. Indesit DIF 14T1 20 pagina's.
Ook voor Indesit DIF 14T1: Gebruiksaanwijzing (20 pagina's)

Pagina afdrukken

Troubleshooting

Whenever the appliance fails to work, check for a solution from the following list before calling for Assistance.

Problem:

The dishwasher does not start or

cannot be controlled.

The door won't close.

No water drains from the

dishwasher.

The dishwasher is too noisy.

The dishes and glasses are

covered in a white film or

limescale deposits.

The dishes and glasses are

streaked or have a bluish tinge.

The crockery has not been dried

properly.

The crockery is not clean.

The dishwasher does not take

any water in - Tap shut-off

alarm.

(beeps are emitted

and all the cycle

indicator lights flash.

The ON/OFF indicator light flashes rapidly

and the 2nd and 3rd wash cycle indicator

lights flash.

Only available in selected models.

Possible causes / Solutions:

• Switch off the appliance by pressing the ON/OFF button, switch it back on

after approximately one minute and reset the program.

• The appliance has not been plugged in properly.

• The dishwasher door has not been shut properly.

• The lock was released. Strongly push the door until a "clacking" noise is

heard.

• The dishwasher cycle has not finished yet.

• The water drain hose is bent (see Installation).

• The drain duct is blocked.

• The filter is clogged up with food residues.

• The dishes are rattling against each other or against the sprayer arms.

• An excessive amount of foam has been produced: the detergent has not

been measured out correctly or it is not suitable for use in dishwashers (see

Start-up and use.)

• The level of refined salt is low or the dosage setting is not suited to the

hardness of the water (see Rinse aid and salt.)

• The lid on the salt dispenser was not closed properly.

• The rinse aid has been used up or the dosage is too low.

• The rinse aid dosage is too high.

• A wash cycle without a drying cycle has been selected.

• The rinse aid has been used up or the dosage is too low (see Rinse aid and

salt).

• The rinse aid setting is not suitable.

• The crockery is made from non-stick material or plastic.

• The racks are overloaded (see Loading the racks.)

• The crockery has not been arranged properly.

• The sprayer arms cannot move freely.

• The wash cycle is too gentle (see Wash cycles.)

• An excessive amount of foam has been produced: the detergent has not

been measured out correctly or it is not suitable for use in dishwashers (see

Start-up and use.)

• The lid on the rinse aid compartment was not shut correctly.

• The filter is dirty or blocked (see Care and maintenance.)

• The refined salt level is low (see Rinse aid and salt.)

• Switch off the appliance by pressing the ON/OFF button. Turn off the water

tap to avoid any flooding and unplug the appliance.

Make sure the water inlet filter has not become blocked by impurities (see "

Care and maintenance" chapter.)

• There is no water in the mains supply.

• The water inlet hose is bent (see Installation.)

• Turn on the tap and the appliance will start after a few minutes.

• The appliance lock has been activated because no action was taken

when the beeps sounded.

• Switch off the machine using the ON/OFF button, turn on the tap and switch

the machine back on after a few seconds by pressing the same button.

Re-program the appliance and restart the wash cycle.