Indesit DVSR 5 Gebruiksaanwijzing - Pagina 7
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Indesit DVSR 5. Indesit DVSR 5 40 pagina's.
Ook voor Indesit DVSR 5: Gebruiksaanwijzing (20 pagina's), Gebruiksaanwijzing (40 pagina's), Gebruiksaanwijzing (40 pagina's)
Pagina afdrukken
Installation
If the appliance must be moved at any time, keep it in an
upright position; if absolutely necessary, it may be tilted onto
its back.
Connecting the water supply
Adaptation of the water supply for installation should only
The water inlet and outlet hoses may be positioned towards
the right or the left in order to achieve the best possible
installation.
hoses.
Connecting the water inlet hose
tap.
If the inlet hose is not long enough, contact a specialist
store or an authorised technician
The water pressure must be within the values indicated
in the Technical Data table - otherwise the dishwasher may
be function properly.
Connecting the water outlet hose
Connect the outlet hose to a drain duct with a minimum
The outlet hose connection must be at a height ranging from
40 to 80 cm from the floor or surface where the dishwasher
rests.
Before connecting the water outlet hose to the sink drain,
Anti-flooding protection
To ensure floods do not occur, the dishwasher:
- is provided with a special system which blocks the water
supply in the event of anomalies or leaks from inside the
appliance.
safety device New Acqua Stop*, which guarantees anti-
flooding protection even in the event of a supply hose rupture.
WARNING: HAZARDOUS VOLTAGE!
as it contains live electrical parts.
Electrical connection
Before inserting the plug into the electrical socket, make
sure that:
regulations;
appliance as shown on the data plate located on the inside
of the door
on the data plate on the inside of the door.
this is not the case, ask an authorised technician to replace
see Assistance
multiple sockets.
Once the appliance has been installed, the power supply
.
cable and the electrical socket should be easily accessible.
The cable should not be bent or compressed.
If the power supply cable is damaged, have it replaced
by the manufacturer or its authorised Technical Assistance
Service in order to prevent all potential hazards.
The Company shall not be held responsible for any
incidents, if these regulations are not observed.
Positioning and levelling
1. Position the dishwasher on a level sturdy floor. If the floor is
uneven, the front feet of the appliance may be adjusted until
it reaches a horizontal position. If the appliance is levelled
correctly, it will be more stable and much less likely to move
or cause vibrations and noise while it is operating.
MAX 80 cm
2. Before recessing the dishwasher, stick the adhesive
MIN 40 cm
transparent strip
it from any condensation which may form.
3. Place the dishwasher so that its sides or back panel are in
contact with the adjacent cabinets or the wall. This appliance
can also be recessed under a single worktop
*
4
. To adjust the height of the rear foot, turn the red hexagonal
bushing on the lower central part at the front of the dishwasher
using a hexagonal spanner with an opening of 8 mm. Turn the
spanner in a clockwise direction to increase the height and
in an anticlockwise direction to decrease it.
*
Only available in selected models.
earthed and complies with current
*
under the wooden shelf in order to protect
.
EN
*
7