Indesit KP9508CXG Gebruiksaanwijzing - Pagina 2

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Indesit KP9508CXG. Indesit KP9508CXG 12 pagina's. Cooker and oven
Ook voor Indesit KP9508CXG: Gebruiksaanwijzing (12 pagina's)

Pagina afdrukken

! Before operating your new appliance please read

this instruction booklet carefully. It contains

important information concerning the safe installation

and operation of the appliance.

! Please keep these operating instructions for future

reference. Make sure that the instructions are kept

with the appliance if it is sold, given away or moved.

! The appliance must be installed by a qualified

professional according to the instructions provided.

! Any necessary adjustment or maintenance must be

performed after the cooker has been disconnected

from the electricity supply.

! It is possible to install the appliance alongside

cupboards whose height does not exceed that of the

hob surface.

! Make sure that the wall in contact with the back of

the appliance is made from a non-flammable, heat-

resistant material (T 90°C).

To install the appliance correctly:

• Place it in the kitchen, the dining room or the bed-

sit (not in the bathroom).

• If the top of the hob is higher than the cupboards,

the appliance must be installed at least 600 mm

away from them.

HOOD

900

Min.

mm.

• Do not position blinds behind the cooker or less

than 200 mm away from its sides.

• Any hoods must be installed according to the

instructions listed in the relevant operating manual.

• If the cooker is

installed underneath a

wall cabinet, there must

be a minimum distance

of 420 mm between this

cabinet and the top of

the hob.

This distance should be

increased to 700 mm if

the wall cabinets are

flammable (see figure).

If it is necessary to level the

appliance, screw the

adjustable feet into the places

provided on each corner of the

base of the cooker (see

figure).

The legs* fit into the slots on

the underside of the base of

the cooker.

WARNING – THIS APPLIANCE MUST BE

EARTHED.

The appliance is designed to work with alternating

current at the supply voltage and frequency indicated

on the rating plate (situated on the rear part of the

appliance and on the last page of the instruction

booklet) or at the end of the instruction booklet. Make

sure that the local supply voltage corresponds to the

voltage indicated on the rating plate.

To connect directly to the mains supply, a double-

pole switch with a contact separation of at least 3

mm suitable for the load and complying with current

standards and regulations, must be fitted between

the appliance and the mains supply outlet. The

yellow-green earth wire must not be interrupted by

the switch. The supply cable must be in such a

position that no part of it can reach a temperature of

50 °C above room temperature. Do not use adapters

or shunts as they could cause heating or burning.

Before connecting to the power supply, make sure

that:

• the limiter valve and the domestic system can

withstand the load from the appliance (see rating

plate);

• the supply system is efficiently earthed according

to standards and laws in force;

• the socket or double-pole switch are easily

accessible when the appliance is installed.

FAILURE TO OBSERVE THE ACCIDENT-

PREVENTION REGULATIONS RELIEVES THE

MANUFACTURER OF ALL LIABILITY.

Important: the wires in the mains lead are coloured

in accordance with the following code: