Indesit K6G40TS Gebruiksaanwijzing - Pagina 21

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Indesit K6G40TS. Indesit K6G40TS 28 pagina's.

Pagina afdrukken

Start-up and use

Using the hob

Lighting the burners

For each BURNER knob there is a complete ring

showing the strength of the flame for the relevant burner.

To light one of the burners on the hob:

1. Bring a flame or gas lighter close to the burner.

2. Press the BURNER knob and turn it in an

anticlockwise direction so that it is pointing to the

maximum flame setting E.

3. Adjust the intensity of the flame to the desired level

by turning the BURNER knob in an anticlockwise

direction. This may be the minimum setting C, the

maximum setting E or any position in between the two.

towards the maximum flame setting, until the burner

is lit.The burner may be extinguished when the knob

is released. If this occurs, repeat the operation,

holding the knob down for a longer period of time.

! If the flame is accidentally extinguished, switch off

the burner and wait for at least 1 minute before

attempting to relight it.

If the appliance is equipped with a flame failure

safety device*(C), press and hold the BURNER knob

for approximately 2-3 seconds to keep the flame

alight and to activate the device.

To switch the burner off, turn the knob until it

reaches the stop position •.

Electric hotplates*

The corresponding knob may be turned clockwise or

anti-clockwise and set to six different positions:

Setting Normal or Fast Plate

Off

Low

2 - 5

Medium

High

When the selector knob is in any position other than

the off position, the 'on' light comes on.

If the appliance is fitted

with an electronic lighting

device* ( X ), press the

ignition button, marked

with the symbol

, then

hold the BURNER knob

down and turn it in an

anticlockwise direction,

Practical advice on using the burners

For the burners to work in the most efficient way

possible and to save on the amount of gas

consumed, it is recommended that only pans that

have a lid and a flat base are used. They should

also be suited to the size of the burner:

Burner

ø Cookware diameter (cm)

Fast (R)

Semi Fast (S)

Auxiliary (A)

To identify the type of burner, please refer to the

diagrams contained in the "Burner and nozzle

specifications".

! For models equipped with a reducer grid, the latter

must be used only for the auxiliary burner, when

pans with a diameter of less than 12 cm are used.

Using the oven

! The first time you use your appliance, heat the empty

oven with its door closed at its maximum temperature

for at least half an hour. Ensure that the room is well

ventilated before switching the oven off and opening

the oven door. The appliance may emit a slightly

unpleasant odour caused by protective substances

used during the manufacturing process burning away.

! Before operating the product, remove all plastic

film from the sides of the appliance.

! Never put objects directly on the bottom of the oven;

this will avoid the enamel coating being damaged.

1. Select the desired cooking mode by turning the

SELECTOR knob.

2. Select the recommended temperature for the

cooking mode or the desired temperature by turning

the THERMOSTAT knob.

A list detailing cooking modes and suggested

cooking temperatures can be found in the relevant

table ( see Oven cooking advice table ).

During cooking it is always possible to:

• Change the cooking mode by turning the

SELECTOR knob.

• Change the temperature by turning the

THERMOSTAT knob.

Only available in certain models.

24 - 26

16 - 20

10 - 14