Indesit WD12X Gebruiksaanwijzing - Pagina 5

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Indesit WD12X. Indesit WD12X 6 pagina's.

Select a programme according to the type of garments that need to be washed. Turn knob A until the selected

programme is aligned with the mark on the knob, turn knob B to the desired temperature settings, check that knob C

is in the desired position, if necessary use buttons E, F, G and lastly, press on/off button H (I position).

At the end of the wash cycle

Lamp I will flash quickly for a few seconds, then it will begin flashing more slowly.

Turn the washer-dryer off by pressing on-off button H (O position). You can now open the washer-dryer door safely.

After having removed the freshly cleaned washing, leave the door open to allow air circulation inside the drum.

Look at the table below and follow the instructions provided for MAX load to have an automatic washing and drying

cycle. Follow the instructions for wash only and use knob C to set the type of drying cycle desired, then press button

H (I position).

If the laundry load to be washed and dried exceeds the maximum load foreseen (see table), then follow the

instructions provided for wash only. When the wash cycle has finished, remove your washing, divide it up and

replace part of it inside the drum. Now follow the instructions provided for a dry only cycle. Repeat this procedure

for the remainder of the load.

Once you have loaded the washing that needs drying (4 kg max. for cottons, see table for other fabrics), make sure

that:

The door is shut correctly;

•

The plug is inserted in the socket; - the water tap is turned on;

•

Button H has not been pressed (O position).

Set the cycle knob

Set knob A on the appropriate drying setting depending on the type of fabric, select the type of drying cycle required

using knob C and then press on-off button H (I position).

At the end of the drying cycle

Wait for lamp 'I' to flash slowly, then turn the washer-dryer off by pressing on-off button H (O position). Now you can

open the appliance door. Once you have removed the washing from the appliance, leave the door open or ajar to

avoid the formation of bad odours.