AEG ABB682F1AF Gebruikershandleiding - Pagina 15
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AEG ABB682F1AF. AEG ABB682F1AF 36 pagina's.
Ook voor AEG ABB682F1AF: Gebruikershandleiding (20 pagina's), Gebruikershandleiding (36 pagina's), Installatie-instructie (20 pagina's)
Pagina afdrukken
Problem
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli‐
ance is too low/too high.
Possible cause
Food products are not wrap‐
ped properly.
Temperature is set incorrect‐
ly.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Temperature set in the appli‐
ance is too low and the am‐
bient temperature is too
high.
The melting water outlet is
not connected to the evapo‐
rative tray below the appli‐
ance.
The Frostmatic function is
switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The Frostmatic function is
switched on.
There is no cold air circula‐
tion in the appliance.
ENGLISH
Solution
Wrap the food products bet‐
ter.
Refer to "Control panel"
chapter.
Set a higher temperature.
Refer to "Control panel"
chapter.
Set a higher temperature.
Refer to "Control panel"
chapter.
Attach the melting water out‐
let to the evaporative tray.
Switch off Frostmatic func‐
tion manually, or wait until
the function deactivates au‐
tomatically to set the temper‐
ature. Refer to "Frostmatic
function" section.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Refer to "Frostmatic func‐
tion" section.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
tips" chapter.
15