AEG AGE62526NW Gebruikershandleiding - Pagina 10
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AEG AGE62526NW. AEG AGE62526NW 12 pagina's.
Ook voor AEG AGE62526NW: Gebruikershandleiding (16 pagina's)
Pagina afdrukken
10
www.aeg.com
Problem
Water flows on the floor.
Temperature cannot be set. The FROSTMATIC or
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
Side panels of the appli-
ance are warm.
Door does not open easily.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.
6.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
7. INSTALLATION
WARNING!
Refer to Safety chapters.
Possible cause
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
COOLMATIC function is
switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The food products temper-
ature is too high.
The FROSTMATIC function
is switched on.
This is a normal state
caused by operation of the
heat exchanger.
You attempted to re-open
the door immediately after
closing.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Solution
Attach the melting water out-
let to the evaporative tray.
Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and dis-
play shuts off for a short time.
Set a higher/lower tempera-
ture.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Refer to "FROSTMATIC func-
tion".
Make sure that there is at least
30 mm of space between each
side of the appliance and the
surrounding furniture when
the ambient temperature ex-
ceeds 38°C.
Wait a few seconds between
closing and re-opening of the
door.