AEG SANTO 70438-5 DT Gebruiksaanwijzing - Pagina 38

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} AEG SANTO 70438-5 DT. AEG SANTO 70438-5 DT 40 pagina's.

Pagina afdrukken

Malfunction

Appliance does not work.

Appliance cools too much.

The food is too warm.

Interior lighting does not

work.

Heavy build up of frost, possi-

bly also on the door seal.

Unusual noises.

The compressor does not start

immediately after changing

the temperature setting.

Water on the floor or on sto-

rage shelves.

Possible Cause

Appliance is not switched on Switch on the appliance.

Mains plug is not plugged in

or is loose.

Fuse has blown or is defective.

Socket is defective.

Temperature is set too cold.

Temperature is not properly

adjusted.

Door was open for an exten-

ded period.

A large quantity of warm

food was placed in the

appliance within the last 24

hours.

The appliance is near a heat

source.

Light bulb is defective.

Door seal is not air tight (pos-

sibly after changing over the

hinges).

Appliance is not level.

The appliance is touching the

wall or other objects.

A component, e.g. a pipe, on

the rear of the appliance is

touching another part of the

appliance or the wall.

This is normal, no error has

occurred.

Water drain hole is blocked.

Remedy

Insert mains plug.

Check fuse, replace if neces-

sary.

Mains malfunctions are to be

corrected by an electrician.

Turn the temperature regula-

tor to a warmer setting tem-

porarily.

Please look in the "Initial Start

Up" section.

Open the door only as long as

necessary.

Turn the temperature regula-

tor to a colder setting tempo-

rarily.

Please look in the "Installation

location" section.

Please look in the "Changing

the Light Bulb" section.

Carefully warm the leaking

sections of the door seal with

a hair dryer (not hotter than

approx. 50 °C). At the same

time shape the warmed door

seal by hand such that it sits

correctly.

Readjust the feet.

Move the appliance slightly.

If necessary, carefully bend

the component out of the

way.

The compressor starts after a

period of time.

See the "Cleaning and Care"

section.