AEG DD 8794 Bedienings- en installatiehandleiding - Pagina 7
Blader online of download pdf Bedienings- en installatiehandleiding voor {categorie_naam} AEG DD 8794. AEG DD 8794 17 pagina's. Electrolux cooker hood range hood models dd 8794 dd 8795 chdd 8795 operating and installation instructions
Ook voor AEG DD 8794: Bedienings- en installatie-instructies (18 pagina's), Bedienings- en installatiehandleiding (22 pagina's), Bedienings- en installatie-instructies (20 pagina's), Bedienings- en installatie-instructies (22 pagina's)
Pagina afdrukken
Switching on the hood - Fig. 3
The control ball is a balancer switch.
Depressing the control ball repeatedly towards the
bottom, switches on the hood and you may select
the suction level desired, depressing once again
the hood switches off.
Switching on the light - Fig. 3
Depress the control ball towards the top :
once for submersed lighting,
once again for full lighting,
depress again to switch off the light.
Control device for grease or
charcoal filter
The air duct, in this hood, is provided with a device
that signals when the filter requires cleaning or
changing .
Led signal for grease filter
The LED signal flickers (flickering green light) when the grease filter
requires cleaning, occurs at about 40 operating hours.
Carefully note the device for grease filter maintenance!
Led signal for charcoal filter
The LED signal flickers (flickering orange light) when the grease filter
requires cleaning, occurs at about 160 operating hours.
Carefully note the device for charcoal filter maintenance!
Re-setting the saturation signal
After cleaning or replacing the filter, select the intensive speed (the
control ball lights up with a red flashing light), depress again and hold
depressed for about 3 seconds until a 'bip' sound indicates the reset.
58
depress towards the
bottom to switch on
the hood.
depress towards
the top to switch
on the lights
Fig. 3