AEG DD 8795 Bedienings- en installatie-instructies - Pagina 7
Blader online of download pdf Bedienings- en installatie-instructies voor {categorie_naam} AEG DD 8795. AEG DD 8795 18 pagina's. Electrolux cooker hood range hood models dd 8794 dd 8795 chdd 8795 operating and installation instructions
Ook voor AEG DD 8795: Bedienings- en installatiehandleiding (17 pagina's), Bedienings- en installatiehandleiding (22 pagina's), Bedienings- en installatie-instructies (20 pagina's), Bedienings- en installatie-instructies (22 pagina's)
Pagina afdrukken
Switching on the hood - Fig. 3
The control ball is a balancer switch.
Depressing the control ball repeatedly towards the
bottom, switches on the hood and you may select
the motor level desired, depressing once again the
hood switches off.
Switching on the light - Fig. 3
Depress the control ball towards the top :
once for submersed lighting,
once again for full lighting,
depress again to switch off the light.
Indicator light for grease or
charcoal filter
The air duct, in this hood, includes a device that
signals when the filter requires cleaning or
changing .
Led signal for grease filter
The LED signal flickers (flickering green light) when the grease filter
requires cleaning, occurs at about 40 operating hours.
Ensure that the indicator light is checked each time the hood is used.
Led signal for charcoal filter
The LED signal flickers (flickering orange light) when
requires cleaning, occurs at about 160 operating hours.
Ensure that the indicator light is checked each time the hood is used.
Re-setting the saturation signal
After cleaning or replacing the filter, select the intensive speed (the
control ball lights up with a red flashing light), depress again and hold
depressed for about 3 seconds until an audible signal indicates the
reset has taken place.
58
depress towards the
bottom to switch on
the hood.
depress towards
the top to switch
on the lights
Fig. 3
the charcoal filter