AEG protect d. 2000 Handleiding voor installatie en gebruik - Pagina 14

Blader online of download pdf Handleiding voor installatie en gebruik voor {categorie_naam} AEG protect d. 2000. AEG protect d. 2000 25 pagina's. Fume extractor hood

Pagina afdrukken
V V V V V iew of the hood
iew of the hood
iew of the hood
iew of the hood
iew of the hood
1. 1. 1. 1. 1. Control panel
2. 2. 2. 2. 2. Lighting units
3. 3. 3. 3. 3. Metal grease filters
4. 4. 4. 4. 4. Telescopic chimney
5. 5. 5. 5. 5. Outlet grids for
Filter version

Hood Operation

Hood Operation
Hood Operation
Hood Operation
Hood Operation
Bild 8
Bild 8
Bild 8
Bild 8
Bild 8
The control panel is located on the front of the hood.
The control panel numbers and symbols (Fig. 8
to right) are explained in the key below:
= Lighting, on/off.
= Fan switch (speeds 1-9).
= Fan timer, 15 minutes.
= Display showing fan speed (1-9), high speed (P),
change grease filters (F) and change activated
carbon filters (C).
= Decrease fan speed button for reducing speed of
motor from high speed (P) down to speed 1.
= Increase fan speed button for increasing speed of
motor from 1 to 9 and high speed (P).
If the hood fails to operate correctly, briefly disconnect it
from the mains power supply for almost 5 sec. by pulling
out the plug. Then plug it in again and try once more
before contacting the Technical Assistance Service.
Always press the
Always press the
Always press the
Always press the
Always press the
from the mains supply
from the mains supply
from the mains supply. . . . .
from the mains supply
from the mains supply
2
3
key before disconnecting the hood
key before disconnecting the hood
key before disconnecting the hood
key before disconnecting the hood
key before disconnecting the hood
4
5
1
3
3
Fig. 8 from left
Fig. 8
Fig. 8
Fig. 8
39