Kohler 1.1785.002 Installatiehandleiding - Pagina 25
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Kohler 1.1785.002. Kohler 1.1785.002 41 pagina's. Thermostatic electric shower
Pagina afdrukken
Bluetooth Pairing
Follow the steps below to pair the shower with a Bluetooth pump. If the shower has
been paired previously and is required to pair with a different pump, it is necessary
to unpair the shower first (see page 24).
OFF
1
Make sure that the BLE PUMP ENABLE
switch is set to ON.
3
Press the start button and hold for
1 2 3 4 5 6 7
7 seconds, the light will flash green and
red indicating that it has entered pairing
mode.
Note! You have 120 seconds to pair the
shower.
If the shower has not been paired previously, the Status light will flash
5
blue for a few seconds while the shower pairs. When the pairing
processes has completed successfully the shower will beep to indicate
that the shower and pump are ready for use, and the Start/Stop
light will change to white. This procedure could take up to 1 minute.
Note: If the shower doesn't pair check the correct parts are being used
and make sure the transformer is within range.
If the shower is already paired when power is applied the Start/Stop light will show
white rather than showing a flashing blue Status indication. If an error code 'B' is
displayed (Start/Stop off with Status flashing yellow) on pressing the Start/Stop
button, the shower may not be paired correctly. Unpair the shower (see page 24)
and repeat the steps above.
ON
BEAB CARE MODE
43 DEG C
45 DEG C
RESERVED 1
ECO
RESERVED 2
BLE PUMP ENABLE
WIRED PUMP MODE
1 2 3 4 5 6 7
10 30 60
1 2
10 30 60
1 2
x1
2
Turn on the power to the pump. The
light will flash red every 4 seconds
indicating that it is not paired.
4
Turn on power to the appliance using
the pull cord.
25
1 2 3 4 5 6 7
10 30 60
1 2
10 30 60
1 2 3 4 5 6 7
1 2
1306246-W2-D