Setting Tool/Outil de pose/Herramienta de fijación
Marble
Anchor/Ancrage/Anclaje
Marbre
Foam Padding
Mármol
Coussinet de mousse
Material protector de espuma
Wood Screw
Vis à bois
Tornillo para madera
Anchor Screw
Vis d'ancrage
Tornillo de anclaje
Install the Lavatory
Cut out the countertop opening by carefully following the pencil line traced from
the template. Position the lavatory in the cutout and verify fit.
NOTE: The provided screws and anchors should be used on countertops with a
minimum 1" (2.5 cm) thickness. For thinner countertops, use appropriate anchors and
fasteners (not provided).
For Wood Countertops:
Mark and pre-drill the wood screw holes at the locations shown on the template.
Waterproof any exposed areas of wood.
For Marble/Stone Countertops:
Position the countertop upside down on foam padding to protect the surface.
Mark and drill 3/8" holes 5/8" (1.6 cm) deep at the locations shown on the
template.
Use a setting tool and hammer to secure the anchors.
For All Installations:
If the countertop has not been installed, install it at this time.
Drill the faucet holes according to the faucet installation instructions.
Install the faucet and drain to the according to the manufacturer's instructions.
Apply a continuous bead of quality sealant to the top surface of the lavatory rim
where it will contact the countertop.
For Marble/Stone Countertops: Install the lavatory to the countertop with the
clamps and anchor screws provided.
For Wood Countertops: Install the lavatory to the countertop with the clamps and
wood screws provided.
For Other Countertop Materials: Refer to the countertop manufacturer's
instructions for recommended fasteners.
IMPORTANT! Risk of product damage. Overtightening the nuts may cause
irreparable damage to the lavatory.
1068257-2-B
Clamp/Pince/Grapa
Apply sealant.
Appliquer du joint d'étanchéité.
Aplique sellador.
6
Kohler Co.
Pagina afdrukken