Kohler Composed K-EX20257T-NWS3-CP Handleiding voor installatie-instructies - Pagina 6

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Kohler Composed K-EX20257T-NWS3-CP. Kohler Composed K-EX20257T-NWS3-CP 14 pagina's. Desk-mount sensor faucet

Pagina afdrukken

1.建议交流电源线采用带绝缘和护套层的电线，导

体标称截面积 0.5mm

称截面积 0.3mm

连接。

2. 排线完毕后，应检查并确保所有排、接线无误，

再分别连接电源盒AC接线端与排线管内交流接线

端，以及电源盒DC接线端(黑橙线接头)与控制组

件的电源线接插件（从阀盒内引出的电线).最后

打开AC电源，龙头进入30秒自动调距阶段，

此过程龙头不会出水。

2.安装直流电池盒组件

Install DC power unit assembly

1. 取出电池盒组件, 旋松螺钉(17),

按电池盒盖(18)上的正负极标示装

入4节5号电池，紧锁电池盒盖(18)

的螺钉(17)后。

注意：电池极性不能装反，新旧电

池不能混用。

3.接线并固定控制盒组件

Cabling and fix the control box

1. 将交流或直流电源盒组件放入

控制盒内。

；直流连接线采用导体标

的电线。请严格按照上图进行

电源盒组件

Power unit assebly

1.Suggested wire: AC connection wire should with insulated

protecting layer or sleeve and the section should be bigger

than 0.5mm

. The section of DC connection wire should be

bigger than 0.3mm

. The connection pattern must according

to illustrations above.

2. After wire layout finished, check and repair if needed.

Then connect AC connector of AC/DC transformer to

electrical source from the control box, and DC connector

of AC/DC transformer to control assembly. Turn on AC

electrical power, faucet will be in the period of automatic

adjusting sensing distance (about 30 seconds). The faucet

will not work during this period.

Install Batteries

1. Assemble AC or DC power unit

assembly into control box.

1495648-T2-A