Kohler K-1018 Installatiehandleiding - Pagina 2

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Kohler K-1018. Kohler K-1018 40 pagina's. Shower modules and receptors
Ook voor Kohler K-1018: Handleiding voor huiseigenaren (8 pagina's)

Pagina afdrukken

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few minutes to review this manual before you start

installation. If you encounter any installation or performance problems, please don't hesitate to contact us. Our

phone numbers and website are listed on the back cover. Thanks again for choosing Kohler Company.

Recommended Tools and Materials

Claw

Drill

Hammer

Drill Bits,1/4"

C-Clamps

& 5/16"

Open End

Box Wrench

Wrench

Before You Begin

CAUTION: Risk of product damage. If extensive shimming is required, all dimensions must be checked and

confirmed. Take extra care when creating centerlines and marking the valve hole and showerhead location.

- Read all instructions before you begin.

- There are two sets of instructions in this installation guide, the receptor and shower wall installation which begins

on page 3, and receptor only installation, which begins on page 13. Refer to the appropriate section.

- Before removing the old unit, inspect your Kohler shower walls and receptor for damage.

- Observe all local plumbing and building codes.

- If you are remodeling, measure the existing framework before removing the old fixture to ensure the new unit

will fit. If needed add or move studs to create the proper stud configuration that is shown.

- To prevent damage, keep the shower components in a safe place until you begin the installation.

- Do not install the shower over open floor joists.

- Make sure there is sufficient access to move the module into the installation location.

- Avoid flexing the sidewalls to prevent damage to the module.

- Insulate all exterior walls before installation

- If ceiling height allows, it is recommended that the showerhead be mounted above the shower wall.

- The Kohler Model K-704516 shower door must be used with this shower module.

- Consult all applicable instructions for accessories and shower doors before beginning this installation.

- Position the rough drain according to the roughing-in dimensions.

1024937-2-

Level

Pencil & Felt

Shims

Tip Marker

Saber

Socket Wrench

Saw

W/Sockets

Tape

Square

Measure

- Conventional woodworking

- Drop Cloth

Safety Glasses

- 2x4's or 2x6's

- Hole saw or saber saw with

- #6 Large- head galvanized

Caulk Gun

Masking

Silicone Sealant

Tape

tools and material.

fine tooth blade (32 teeth per

inch)

nails

Kohler Co.