AEG ADS854R5SB Gebruikershandleiding - Pagina 27
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AEG ADS854R5SB. AEG ADS854R5SB 32 pagina's.
Pagina afdrukken
metres in length at 100mm diameter.
If connecting the dryer to a common
ducting system, safety advice should be
requested from the manufacturer.
If you choose to use included kit, the
exhaust grille at the front of the dryer will
need to be replaced with the outlet cover
from the back of the dryer. Gently prise
open the grille, using a thin bladed tool.
Next, remove the cover from the back
and clip it into the grille space at the
front.
The exhaust grille is not required when
using a vent kit.
You can position the vent kit at the back
of the dryer to remove air upwards or
sideways.
air flow
Inlet and outlet points need clear airflow
to prevent overheating, so ensure there
is adequate ventilation. (i.e. open
window or external door.)
If a venting kit is used and the exhaust is
discharged out of the room, there must
be adequate ventilation to avoid the
back flow of gases in to the room from
appliances burning other fuels, including
open fires, when operating the tumble
dryer. This is not applicable where a
venting hose is directed to an open
window.
The exhaust air must not be discharged
into a flue which is used for exhausting
fumes from appliances burning gas or
other fuels.
11.3 Machine Leveling
It is important that your Dryer stands
firm and leveled on the floor to ensure
correct operation. The appliance must
not be installed behind a lockable door,
a sliding door or a door with a hinge on
the opposite side to avoid restricting the
Dryer door.
Use a spirit level on the top and side of
the Dryer to check the levels.
If you do not have a spirit level, as a
guide use the edge of a door frame,
cupboard or bench to check that the
Dryer is leveled.
Never place cardboard, wood or similar
air flow
materials under the machine to
compensate for any unevenness in the
floor. Install the machine on a flat hard
floor. Make sure that air circulation
around the machine is not impeded by
carpets, rugs etc.
Check that the machine does not touch
the wall or cupboard units.
27