AEG LAVATHERM 55600 Gebruikersinformatie - Pagina 21

Blader online of download pdf Gebruikersinformatie voor {categorie_naam} AEG LAVATHERM 55600. AEG LAVATHERM 55600 32 pagina's. Condensation dryer

Problem

Drying cycle lasts an

unusually long time.

Note:

After around 5 hours

the drying cycle ends

automatically (see

„Drying cycle com-

plete").

Changing bulb for inside light

Only use a special bulb which is designed specially for dryers. The spe-

cial bulb is available from the after-sales service,

ET-Nr. 112 552 000-5.

Warning! Do not use standard bulbs! These develop too much heat and

may damage the machine!

Warning! Before replacing the bulb, disconnect the mains plug; with a

permanent connection: fully unscrew or deactivate the fuse.

1. Unscrew covering bonnet from above bulb (this can be found directly

behind the loading aperture, at the top; refer to "Description of ma-

chine" section.)

2. Replace defective bulb.

3. Screw covering bonnet back down.

Warning! For reasons associated with safety, the covering bonnet must

be screwed down tightly. If this is not done, the dryer must not be op-

erated.

Possible cause

Lint filter clogged.

Heat exchanger clogged

with lint.

SPECIAL CARE (LAGE TEMP.)

button pressed and load

volume too big.

Load volume too big.

Laundry insufficiently pre-

drained.

Remedy

Clean lint filter.

Clean heat exchanger.

SPECIAL CARE (LAGE TEMP.) is

only suitable for use with

loads of up to 2,5kg!

Reduce load volume.

Laundry must be adequately

pre-drained.