AEG LAVATHERM 56800 Gebruikersinformatie - Pagina 20
Blader online of download pdf Gebruikersinformatie voor {categorie_naam} AEG LAVATHERM 56800. AEG LAVATHERM 56800 36 pagina's. Electrolux user information condenser dryer 56800
Pagina afdrukken
Problem
Drying results unsatis-
factory.
Loading door does not
close.
When pressing a but-
ton, the corresponding
button flashes several
times.
Drum light does not
work.
Programme inactive,
EMPTY WATER display
illuminated.
Drying cycle ends
shortly after pro-
gramme starts. END
display illuminated.
20
Possible cause
Wrong programme selected.
Lint filter clogged.
Heat exchanger clogged
with lint.
Overloading of laundry.
Ventilation slots in base area
covered up.
Residue on inside surface of
drum or drum ribs.
Conductance of water at in-
stallation site differs from
standard setting of ma-
chine.
Fine strainer not in place
and/or large mesh filter not
locked in place.
Washing protection. After
the start of the programme,
the option can no longer be
set.
Programme selector in OFF
position.
Defective lamp.
Condensate tank is full.
Not enough washing load-
ed or washing loaded is too
dry for selected programme.
Remedy
Select a different programme
the next time you dry
(see "Overview of pro-
grammes" section).
Clean lint filter.
Clean heat exchanger.
Observe recommended load-
ing volumes.
Uncover ventilation slots in
base area.
Clean inside surface of drum
and drum ribs.
Re-programme standard set-
ting for degree of drying (see
'Programming options' sec-
tion).
Install fine strainer and/or
snap large mesh filter into
place.
Turn the programme knob to
OFF. Set the programme again.
Turn programme selector to
LIGHT or to any programme.
Replace lamp (see next sec-
tion).
Empty condensate tank, then
start programme with START/
PAUSE button.
Select time programme or
higher drying level (e.g. INTEN-
SIVE DRY instead of STORAGE
DRY).