AEG LAVATHERM 7041 TK ELECTRONIC Gebruikersinformatie - Pagina 22

Blader online of download pdf Gebruikersinformatie voor {categorie_naam} AEG LAVATHERM 7041 TK ELECTRONIC. AEG LAVATHERM 7041 TK ELECTRONIC 32 pagina's. Condensation dryer

Problem
Programme inactive,
EMPTY WATER (BEHÄL-
TER) display illuminat-
ed.
Drying cycle ends
shortly after pro-
gramme starts. END
(ENDE) display illumi-
nated.
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle com-
plete").

Changing bulb for inside light

Only use a special bulb which is designed specially for dryers. The spe-
cial bulb is available from the after-sales service,
ET-Nr. 112 552 000-5.
1
Warning! Do not use standard bulbs! These develop too much heat and
may damage the machine!
1
Warning! Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully unscrew or deactivate the fuse.
1. Unscrew covering bonnet from above bulb (this can be found directly
behind the loading aperture, at the top; refer to "Description of ma-
chine" section.)
2. Replace defective bulb.
3. Screw covering bonnet back down.
1
Warning! For reasons associated with safety, the covering bonnet must
be screwed down tightly. If this is not done, the dryer must not be op-
erated.
22
Possible cause
Condensate tank is full.
Not enough washing load-
ed or washing loaded is too
dry for selected programme.
Lint filter clogged.
Heat exchanger clogged
with lint.
SPECIAL CARE (SCHON) but-
ton pressed and load vol-
ume too big.
Load volume too big.
Laundry insufficiently pre-
drained.
Remedy
Empty condensate tank, then
start programme with START/
PAUSE button.
Select time programme or
higher drying level (e.g. INTEN-
SIVE DRY [STARKTROCKEN] in-
stead of STORAGE DRY
[SCHRANKTROCKEN]).
Clean lint filter.
Clean heat exchanger.
SPECIAL CARE (SCHON) is only
suitable for use with loads of
up to 3kg!
Reduce load volume.
Laundry must be adequately
pre-drained.