AEG LAVATHERM 75280AC Gebruikershandleiding - Pagina 12
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AEG LAVATHERM 75280AC. AEG LAVATHERM 75280AC 24 pagina's.
Ook voor AEG LAVATHERM 75280AC: Gebruikershandleiding (28 pagina's), Gebruikershandleiding (24 pagina's)
12 www.aeg.com
• after you push the Start/Pause button
- all the push buttons and the pro-
gramme dial are deactivated
7.14 Starting a programme
To activate the programme push the
Start/Pause button. The LED above the
push button changes the colour to red.
7.15 Change a programme
To change a programme, push the On/
Off button to deactivate appliance. Push
the On/Off to activate the appliance and
then set the programme again.
8. HINTS AND TIPS
8.1 Ecological hints
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry
becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If necessary
clean the condensate before (e.g. with
a coffee filter) to remove possible
small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Use the load volumes specified in the
programmes chapter.
• Make sure that is good airflow in the
appliance installation position.
• Clean the filter after each drying cycle.
• Spin good the laundry before drying.
8.2 Water hardness and
conductivity
Water hardness can be different for dif-
ferent locations. Water hardness has an
effect on the water conductivity and the
operation of the conductivity sensor in
the appliance. If you know the value of
7.16 At the end of programme
When the drying cycle is completed, the
symbol flashes on the display. If the
Buzzer function is on, an acoustic signal
sounds intermittently for one minute.
To remove the laundry:
1.
Push the On/Off button for 2 sec-
onds to deactivate the appliance.
2.
Open the appliance door.
3.
Remove the laundry.
4.
Close the appliance door.
After each drying cycle:
• clean the filter
• drain the water container
(See chapter CARE AND CLEANING.)
the water conductivity you can adjust the
sensor to dry with the better results.
To change the sensor conductivity:
1.
Turn the programme dial to availa-
ble programme.
2.
Push at the same time the Dry Plus
and the Anticrease buttons. Hold
down until one of the symbols go in-
to view on the display:
–
low conductivity <300 μS/
cm
–
moderate conductivity
300-600 μS/cm
–
high conductivity >600
μS/cm
3.
Push the Start Pause button again
and again until you set necessary
level.
4.
To memorise the setting push at the
same time the Dry Plus and the Anti-
crease buttons.