AEG Lavatherm 76280AC Gebruikershandleiding - Pagina 16
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AEG Lavatherm 76280AC. AEG Lavatherm 76280AC 24 pagina's.
Ook voor AEG Lavatherm 76280AC: Gebruikershandleiding (36 pagina's), Gebruikershandleiding (28 pagina's), Gebruikershandleiding (28 pagina's)
Pagina afdrukken
16
www.aeg.com
9.10 Programme end
If the drying cycle is completed, the
symbol
Buzzer option is on, the acoustic signal
sounds intermittently for 1 minute.
10. HINTS AND TIPS
10.1 Ecological hints
• Spin good the laundry before drying.
• Use the load volumes which are
specified in the programme chart.
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g.
with a coffee filter) to remove possible
small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Make sure that is good airflow in the
appliance installation position.
10.2 Adjustment of the
remaining laundry moisture
degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Dry Plus and Anti-crease
buttons.
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
flashes on the display. If the
If you do not turn off the
appliance, the crease guard
phase starts. Laundry can be
removed during this phase.
To remove the laundry:
1. Push the On/Off button for 2
seconds to turn off the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
One of the symbols goes into the view
on the display:
- the maximum dry laundry
- the more dry laundry
- the standard dry laundry
5. Push the Start/Pause button again
and again until you set necessary
degree.
6. To memorise the setting, push at the
same time the Dry Plus and Anti-
crease buttons for approximately 2
seconds.
10.3 Deactivating the Tank
indicator
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Dry Plus and Buzzer
buttons.
One of 2 configurations is possible:
• the Tank indicator: is on and the
symbol
view - the water container
indicator is permanently on
• the Tank indicator: is off and the
symbol
view - the water container
indicator is permanently off
goes into the
goes into the