AEG LAVATHERM T57819 Gebruikersinformatie - Pagina 23

Blader online of download pdf Gebruikersinformatie voor {categorie_naam} AEG LAVATHERM T57819. AEG LAVATHERM T57819 33 pagina's. Condensation dryer

Pagina afdrukken

Problem

Drying cycle lasts an

unusually long time.

Note:

After around 5 hours

the drying cycle ends

automatically (see

„Drying cycle complete").

Drying cycle ends

shortly after programme

starts. END display illumina-

ted.

Changing bulb for inside light

Only use a special bulb which is designed specially for dryers. The special bulb

is available from the after-sales service, ET-Nr. 112 552 000-5.

Warning! Do not use standard bulbs! These develop too much heat and

may damage the machine!

Warning! Before replacing the bulb, disconnect the mains plug; with a

permanent connection: fully unscrew or deactivate the fuse.

1. Unscrew covering bonnet from above bulb (this can be found directly behind

the loading aperture, at the top; refer to "Description of machine" section.)

2. Replace defective bulb.

3. Screw covering bonnet back down.

Warning! For reasons associated with safety, the covering bonnet must

be screwed down tightly. If this is not done, the dryer must not be operated.

Possible cause

Lint filter clogged.

Heat exchanger clogged

with lint.

SPECIAL CARE

button pressed and load

volume too big.

Load volume too big.

Laundry insufficiently pre-

drained.

Not enough washing loaded

or washing loaded is too

dry for selected programme.

Remedy

Clean lint filter.

Clean heat exchanger.

SPECIAL CARE is only suita-

ble for use with

loads of up to 3 kg!

Reduce load volume.

Laundry must be adequately

pre-drained.

Select time programme or

higher drying level (e.g.

INTENSIVE DRY instead of

STORAGE DRY).