AEG TR85CW84 Gebruikershandleiding - Pagina 19
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AEG TR85CW84. AEG TR85CW84 36 pagina's.
Pagina afdrukken
In case of drum overload,
the maximum declared load
indicator comes on again
with the
blinking. In this case, during
these 30 seconds, it is
possible to open the door
and remove the exceeding
garments. Once removed,
touch the Start/Pause button
to start the programme
again. If the laundry amount
will not be reduced, the
programme starts anyway.
In this case, it will be not
possible to guarantee the
best results.
8.10 Program change
To change a program:
1. Push the On/Off button to turn the
appliance off.
2. Push the On/Off button again to turn
on the appliance.
3. Set a new program.
8.11 Programme end
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is finished, the symbol
appears on the display. If the Buzzer
option is activated, the acoustic signal
sounds intermittently for 1 minute.
If you do not turn off the
appliance, the anti-crease
phase starts (not active with
all programmes). Flashing
execution of the anti-crease
phase. Laundry can be
removed during this phase.
9. HINTS AND TIPS
9.1 Ecological hints
• Spin the laundry well before drying.
indicator
symbol signals the
To remove the laundry:
1. Push the On/Off button for 2 seconds
to turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying
results:
• Inadequate default dryness level
settings. See chapter
default dryness level
• Room temperature is too low or too
high. Optimal room temperature is
between 18°-25°C.
8.12 Drum light on
Touch and hold down Silent button by
around 3 seconds.
The light inside the drum is on.
8.13 Possible causes of
unsatisfactory drying results:
• The filter is clogged. Clogged filter
makes drying inefficient.
• The airflow slots are clogged.
• The humidity sensor is dirty.
• The drum is dirty.
• Inadequate default dryness level
settings. See chapter
default dryness level
• Room temperature is too low or too
high. Optimal room temperature is
between 18°-25°C.
• Do not exceed the load sizes which
are specified in the programmes
chapter.
ENGLISH
19
Adjustment of
Adjustment of