Kohler K-1126 Installatiehandleiding - Pagina 12

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Kohler K-1126. Kohler K-1126 44 pagina's. Bath whirlpool
Ook voor Kohler K-1126: Handleiding voor huiseigenaren (32 pagina's), Installatiehandleiding (48 pagina's), Installatiehandleiding (44 pagina's), Inloophandleiding (4 pagina's), Installatiehandleiding (48 pagina's)

Remove the Jets

Insert the tool hook as shown and pull the jet out of the

housing. The jet should be facing up when this is done.

Troubleshooting

NOTICE: This section is for general aid only. A Kohler Authorized Service Representative or qualiﬁed

electrician should correct any electrical problems. For warranty service, contact your dealer or wholesale

distributor.

Remove the Jets

NOTE: A special tool is provided with the replacement jets that will allow you to remove the jets from the

whirlpool. This tool is also supplied with each trim kit.

Position the jet ball nozzle so it is pointing upward.

NOTE: The nozzle must remain pointed up or the tool will slip off.

Insert the removal tool, hooked end up, into the opening of the jet and hook the inside top of the

nozzle.

Grasp the tool ﬁrmly and place your thumb against the whirlpool wall. Pull steadily on the tool

until the jet assembly pulls free of the hole. Be careful not to lose the O-ring.

Reinstall the Jets

NOTE: To allow easy rotation and proper operation of the jet, the O-ring must be: (1) correctly positioned,

(2) lubricated, and (3) in good condition.

Install the O-ring onto the ﬁrst shoulder of the jet.

Using the silicone lube packet (provided), lubricate the O-ring to prevent noisy operation of the jet.

Carefully insert the jet into the housing, then lightly push and rotate the jet until it snaps into

position. Do not force the jet.

Verify the jet is installed correctly. The jet should turn smoothly both clockwise and

counterclockwise. Remove and reinstall, if necessary.

1011092-2-F

Reinstall the Jets

Slide the O-ring

onto the first

shoulder of the jet.

Insert the jet into the housing, and lightly

push and rotate until it snaps in position.

Housing

Inspect and

lubricate the O-ring.

Kohler Co.