Kohler Command PRO CH26 Gebruikershandleiding - Pagina 15
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Kohler Command PRO CH26. Kohler Command PRO CH26 21 pagina's. Command series
Ook voor Kohler Command PRO CH26: Gebruikershandleiding (21 pagina's), Gebruikershandleiding (21 pagina's), Gebruikershandleiding (21 pagina's), Gebruikershandleiding (8 pagina's), Gebruikershandleiding (14 pagina's)
Pagina afdrukken
Make sure the proper fuel filter is being used, and
it is clean and unobstructed. Replace filter only
with genuine Kohler parts.
Make sure all connections to sensors, ECU, and
fuel injectors are properly secured.
Make sure a good 12 volt battery is being used and
is fully charged.
If these checks do not correct the problem, or the MIL
remains on, further diagnosis and servicing by an
authorized Kohler Engine Dealer is necessary.
Adjustment
-
EFI Throttle Body
Low Idle Speed (RPM) is the only adjustment that can
be made. All other fuel calibrations are permanently
preset and controlled by the ECU. The standard low idle
speed is 1500 RPM"
(k
75
RPM).
*NOTE: The actual low idle speed depends on the
application
--
refer to equipment
manufacturer's recommendations.
When an EFI engine is started cold, the ECU will be
using internal programming for cold running, and the
idle speed may vary from the manual setting. Do not
attempt to perform any readjustment during this "warm-
up" period.
If adjustment is to be made, the engine must be at
operating temperature, air cleaner in place, and check
engine light must be off (no fault codes present).
1. Start the engine and run at half throttle for 5 to 10
minutes to warm up.
2.
Place the throttle control into the "id1e"or "slow"
position.
3. Turn the low idle speed adjusting screw in or out
and check RPM with a tachometer. See Figure
17.
Adiustina Screw
I
Figure
17,
EFI Throttle Body Manifold.
Troubleshooting
When troubles occur, be sure to check the simple causes which, at first, may seem too obvious to be considered.
For example, a starting problem could be caused by an empty fuel tank. Some common causes of engine troubles
are listed in the following table.
Do not attempt to service or replace major engine components, or any items that require special timing or
adjustment procedures. Have your Kohler Engine Service Dealer do this work.
Possible Cause No
Improper
Dirt In
Dirty
Incorrect
Engine
Dirty Air
Faulty
Problem
Fuel
Fuel Fuel Line/System Grass Screen Oil Level
Overloaded
Cleaner
Spark Plug
Will Not Start
Hard Starting
Stops Suddenly
Lacks Power
Operates Erratically
Knocks or Pings
Skips or Misfires
Backfires
Overheats
High Fuel Consumption
15