Kohler Command PRO ECV749 Gebruikershandleiding - Pagina 13
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Kohler Command PRO ECV749. Kohler Command PRO ECV749 21 pagina's. Vertical crankshaft
Ook voor Kohler Command PRO ECV749: Gebruikershandleiding (8 pagina's)
Fuse
Holder
Figure 15. Fuse Holders and Covers.
4. Inspect the fuse for a broken fusible link. See
Figure 16. Replace the fuse if the fusible link is
broken. If you are not sure if the link is broken,
replace the fuse.
Additional Electrical Information
The yellow accessory wire from on the original Kohler Engine key switch can not draw more than 2-amps. A
relay may be used in order to use a higher drawing accessory. Contact a Kohler Engines application specialist for
further instructions. A current draw of more than 2-amps will cause damage to the ECU, Fuel Pump Module, or
other electrical system components and will void the warranty.
Troubleshooting
When troubles occur, be sure to check the simple causes which, at first, may seem too obvious to be considered.
For example, a starting problem could be caused by an empty fuel tank. Some common causes of engine troubles
are listed in the following table.
Do not attempt to service or replace major engine components, or any items that require special timing or
adjustment procedures. Have your Kohler Engine Service Center do this work.
Problem
No
Fuel
Will Not Start
Hard Starting
Stops Suddenly
Lacks Power
Operates
Erratically
Knocks or Pings
Skips or Misfires
Backfires
Overheats
High Fuel
Consumption
Cover
Improper
Blocked
Low
Fuel
Fuel
Battery
Line/
Voltage
System
Solid
Fusible Link
Good Fuse
Figure 16. Good and No Good Blade Type Fuses.
5. Install the fuse into the fuse holder until it is
seated properly. Install the fuse cover.
Possible Cause
Broken
Dirty
Incorrect
Fusible
Fixed
Oil Level
Link
Guard
Broken
Fusible Link
No Good Fuse
Engine
Dirty Air
Faulty
Overloaded
Cleaner
Spark
Plug
13