Kohler SV810-840 Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Kohler SV810-840. Kohler SV810-840 21 pagina's. Vertical crankshaft
Ook voor Kohler SV810-840: Gebruikershandleiding (21 pagina's), Gebruikershandleiding (20 pagina's)

Pagina afdrukken

Refer to the operating instructions of the equipment

this engine powers. Because of equipment design or

application, there may be more stringent restrictions

regarding the angle of operation.

NOTE: Do not operate this engine continuously

at angles exceeding 25° in any direction.

Engine damage could result from insuﬃcient

lubrication.

Cooling

NOTE: If debris builds up on the grass screen or other

cooling areas, stop the engine immediately

and clean. Operating the engine with blocked

or dirty air intake and cooling areas can cause

extensive damage due to overheating. See

Clean Air Intake/Cooling Area.

Maintenance Instructions

Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the

customers expense, may be performed by any non-road engine repair establishment or individual. Warranty

repairs must be performed by an authorized Kohler service outlet.

WARNING: Accidental Starts!

Disabling engine. Accidental starting can cause severe injury or death. Before working on the engine or

equipment, disable the engine as follows: 1) Disconnect the spark plug lead(s). 2) Disconnect negative (-) ba ery

cable from ba ery.

Maintenance Schedule

These required maintenance procedures should be performed at the frequency stated in the table. They should

also be included as part of any seasonal tune-up.

Frequency

Daily Or Before

Starting Engine

Every 25 Hours

Every 50 Hours

Annually or

Every 100 Hours

Every 200 Hours

Every 500 Hours

Perform these maintenance procedures more frequently under extremely dusty, dirty conditions.

Have a Kohler Engine Service Dealer perform these services.

Check Oil Level

The importance of checking and maintaining

the proper oil level in the crankcase cannot be

overemphasized. Check oil BEFORE EACH USE as

follows:

Maintenance Required

• Fill fuel tank.

• Check oil level.

• Check air cleaner for dirty

• Check air intake and cooling areas, clean as necessary

• Service precleaner element

• Check air cleaner element, clean or replace as necessary¹.

• Replace air cleaner element and precleaner¹.

• Change oil and oil ﬁlter (more frequently under severe conditions).

• Remove cooling shrouds and clean cooling areas¹.

• Replace fuel ﬁlter.

• Check spark plug condition and gap.

• Have valve lash checked/adjusted

• Have bendix starter drive serviced

• Have solenoid shi starter disassembled and cleaned

WARNING: Hot Parts!

Engine components can get extremely hot from operation.

To prevent severe burns, do not touch these areas while

the engine is running, or immediately a er it is turned

oﬀ. Never operate the engine with heat shields or guards

removed.

Engine Speed

NOTE: Do not tamper with the governor se ing

to increase the maximum engine speed.

Overspeed is hazardous and will void the

engine warranty. The maximum allowable

high idle speed for these engines is 3675 RPM,

no load.

, loose, or damaged parts.

1. Make sure the engine is stopped, level, and is cool

so the oil has had time to drain into the sump.

2. Clean the area around and the underside of the

oil ﬁll cap/dipstick before removing it. This will

help keep dirt, debris, and other foreign ma er

out of the engine.