Kohler KDI 1903M Gebruikershandleiding - Pagina 19
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Kohler KDI 1903M. Kohler KDI 1903M 38 pagina's. Diesel kdi
Ook voor Kohler KDI 1903M: Gebruikershandleiding (40 pagina's), Gebruikershandleiding (50 pagina's), Gebruik en onderhoud (42 pagina's)
3.1 Pre-start check
• Read carefully the following pages and carry out the
operations described below in accordance with the
instructions specified.
Important
• Non compliance with the operations described in the following
pages involves the risk of damages to the engine and vehicle
on which it is installed as well as personal and/or property
damage.
3.2 Break-in running
NOTE: For the first 50 hours of engine operation, it is advisable not to exceed 75% of the maximum power supplied.
3.3 Starting and turning off
3.3.1
Starting
1 -
Check the level of the engine oil, fuel and coolant and fill if necessary (Par. 3.5 and Par.
2 - Put the ignition key in the ignition switch (if supplied).
3 - Tun the key to ON position.
4 - Turn the key beyond the ON position and release it when the engine starts (the key will return into ON position automatically).
Important
• Do not actuate the starter for more than 15 seconds at a time. If the engine does not start, wait for one minute before repeating
attempt.
• If engine does not start after two attempts see Tab. 6.1 and Tab.
3.3.2
After starting
Warning
• Make sure that all the warning lights on the control panel are off when the engine is running.
1 - Run at minimum speed for a few minutes according to table (except constant speed engine).
AMBIENT TEMPERATURE
≤ -20°C
from -20° C to -10°C
from -10° C to -5° C
from -5° C to 5° C
≥ 5° C
UM KDI 1903M_2504M _ cod. ED0053029510 - 2° ed_rev. 01
INFORMATION ABOUT USE
• Increase the frequency of maintenance operations in heavy
working conditions (engine starts but stops, very dusty and
hot environments, etc...).
6.2 to found the cause.
TIME
2 minutes
1 minutes
30 seconds
20 seconds
15 seconds
3.6).
Index
3
EN
19