Kohler RIVLET K-31534K-CP Handleiding voor installatie-instructies - Pagina 3
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Kohler RIVLET K-31534K-CP. Kohler RIVLET K-31534K-CP 8 pagina's.
INSTALLATION
Install
A Refer to the Installation Instructions of the matching
washbasin, make a hole on the wall in advance, and knock
in the embedded part.
B Install the faucet and the sink according to the Installation
Instructions of corresponding manufacturers.
C Adjust the adjusting feet under the feet of the cabinet and
use a level to ensure that the upper end of the cabinet is
horizontal at the position where the cabinet is installed.
Install Washbasin Cabinet
安装脸盆柜
1. Lift the cabinet and washbasin slightly with 2-4 people. First, align the basin's suspension holes with the wall's pre-made
basin suspension bolts, pass the bolts through the basin holes, and translate the cabinet and basin until close to the wall.
1. 由2-4人稍稍抬起柜体和台盆,先将台盆悬挂孔对准墙面预先打好的台盆悬挂螺栓,使螺栓穿过台盆孔,并将柜体和台盆平移
直到与墙面紧贴。
2. Open the cabinet door and drawer. Fix the bolt according the vanity installation instructions. Before that, please apply
silicone sealant onto the contact surface of the vanity and the wall.
2. 将柜体的门和抽屉打开,按照台盆说明书固定悬挂螺栓,固定前用硅胶枪在台盆和墙面接触面均匀涂上硅胶。
3. Connect water pipe and drain by professionals to ensure there is no leakage.
3. 由专业人员连接上下水,确保无渗漏。
Note:
Different types of bolts are required for
different decoration boards. Please apply
suitable bolts and plugs.
注意:
不同的装饰墙面需要不同型号的螺钉,请使
用合适的螺钉和入墙胶塞。
Connect Drainage
连接排水管
a. Inwall drainage (P-Trap) for washbasin
Please install the washbasin drain assembly and faucet as shown.
Please install foot basin drain assembly and supply line as shown.
Please set the water supply and drainage position according to the
supplier's instructions.
The foot basin drain pipe must be placed through the hoop as shown.
Note: The inlet pipe for foot basin must be connected with Cold (C) inlet;
The foot basin is only suitable for floor drainage.
a. 入墙式排水管(P弯管)
请按照如图所示安装脸盆排水管和龙头。
请按照如图所示安装洗脚盆排水管和进水。
请遵照供应商所提供的说明书在墙上设置进/排水管位置。
洗脚盆排水管必须如图示放入卡环。
注:洗脚盆进水管只能接冷水入口;洗脚盆只能使用地排水。
1472252-T01-C
Foot Basin Drain Assembly
洗脚盆排水管
Hoop
卡环
-3-
安装
安装之前
A 参考配套台盆的说明书,在墙面上预先打好挂盆的孔,并敲入
预埋件。
B 按照龙头和落水的制造商的安装说明安装龙头和落水。
C 调整柜体脚下的调节脚,用水平尺检测,确保柜体所安装的位
置处柜体上端面是水平的。
Nut
Washer
螺母
垫片
Off set Nut
偏移螺母
STEP
1
Faucet
龙头
Faucet Supply Lines
龙头供水管
Shut-off Valve
止水阀
Washbasin Drain
Assembly
脸盆排水管
Foot Basin Supply Line
洗脚盆供水管
Foot Basin Drain
Assembly
洗脚盆排水管
STEP
2