a-TroniX PPS Solar flex Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} a-TroniX PPS Solar flex. a-TroniX PPS Solar flex 8 pagina's. Flexible solar module

Pagina afdrukken

User Manual

a-TroniX PPS solar flex

2. Safety instructions

Please keep these operating instructions and read them before use.

Observe the safety instructions.

Installation is the customer's responsibility within the framework of the Low Voltage

Directive 2014/35/EU and not the responsibility of AKKU SYS Akkumulator- und

Batterietechnik Nord GmbH.

AKKU SYS Akkumulator- und Batterietechnik Nord GmbH is not responsible for any

damage caused by the user's failure to follow the instructions and improper handling.

CAUTION:

If several modules are connected in series, the total voltage increases (Low

Voltage Directive 2014/35/EU). The installation should then only be carried

out by a specialist company. In case of injuries and accidents of any kind, the

installer himself is liable.

When you receive the goods, make sure that you use suitable tools to

■

unpack them in order to prevent damage to the module. Check for any

damage that may have occurred during transport. If the product is damaged

or does not function properly, do not use it. Contact your supplier.

Make sure that no sharp or heavy objects damage the surface of the solar

■

module.

Do not drill any additional holes on the frame or the surface of the module.

Prevent rain, moisture or water from entering the electrical connections and

■

do not carry out any work on your solar system in rain or strong winds.

Transport and handle the modules as carefully as possible on the outside

■

of the frame. Do not grip in the middle of one side of the module in order

not to exceed the max. bending radius. It is recommended to transport the

modules and mount them on a roof with two people if possible.

Do not walk or stand on the modules.

Use only approved, insulated tools and do not touch exposed electrical

■

conductors.

When wiring the connections, ensure the correct polarity to avoid short

■

circuits.

For the electrical connections of your solar system, use only modules of the

same type and the cables and connections intended for them.

The recommended cable cross-section is 4 mm².

Page 4

09/2021