Dexin RX28-1M Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dexin RX28-1M. Dexin RX28-1M 8 pagina's. Wireless 3 buttons optical mouse

Move the receiver and the mouse closer to each other so that the receiver is relatively

shorter in distance to the mouse than to other 27MHz transmitters. You may need to

re-establish the "connection".

Note: Avoid using this device on a metal surface because a large surface of iron, aluminum,

copper, or other metal may act like a shielding to the RF antenna of the mouse and the receiver.

3. Interference with other RF wireless mouse

If the interference comes from other same model of RF wireless mice, please "Setting up

connection between mouse and receiver" of the installation guide to switch to a new RF

channel. A new identification code is also generated upon the completion of channel

switching.

Normally, the effective transmission distance is about 3 feet, depending on the environment. If

the effective distance between the mouse and the receiver is bad, try to change the location of

the receiver.

4. If you have difficulty connecting the wireless mouse:

Increase the distance between the set of wireless mouse and other radio device units.

Turn off the other wireless devices, or their base units that are in close proximity to the

receiver of this wireless mouse.

Try connecting the wireless mouse and its receiver again.

To verify that your device is connected and working properly, open a document and try the

device.

Electromagnetic Characteristics (EMC)

Tested to comply with FCC standards

For home or office use

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one of the following measures:

MWP141-P1M 27MHz Wireless Optical Mouse

Federal Communication Commission Interference Statement

page 7 of 8

1.0 Edition