Aqua Control AirPro 4 Installatie- en gebruikershandleiding - Pagina 5

Blader online of download pdf Installatie- en gebruikershandleiding voor {categorie_naam} Aqua Control AirPro 4. Aqua Control AirPro 4 6 pagina's. Lake bed aeration

Pagina afdrukken

Timer Setting (AirPro models only)

Remove the clear cover by pulling it straight out from the timer. Review the following instructions for proper operation.

There are three positions for the power switch:

Use timer settings mode

Maintenance and Troubleshooting

Keep the cabinet air inlets and outlets free of debris and weed growth for proper ventilation.

If the system does not power on:

Press and reset the GFCI electrical receptacle located inside the cabinet. For AirPro models with timers: if the compressor(s)

still won't turn on, check that the timer is set correctly. If the timer is correctly set and the compressor(s) still won't operate,

flip up the white manual override toggle located ner the center-right on the timer. If it still won't power on, contact your

distributor or the factory for further assistance.

Note: Before performing any of the following maintenance or troubleshooting, unplug the system from any power outlet.

If the size or appearance of the surface aeration has decreased from initial installation, perform on or more of the following:

Always on positon

The time switch is

set by pushing the

captive trippers to

the outer rings

position in (green)

the Lake Bed

Aerator will be

turned on for that

period. Each tripper

represents 15

minutes. When they

are on the inner

position the Lake

Bed Aerator will not

turn on during

these positions.

O position

Turn the minute hand (shown in red)

clockwise until the current time is aligned

with the triangle (shown in green) on the

inner dial. The hour and the minute dial

will show exactly the current time. Snap

the clear cover back onto the timer.

Lake Bed Aeration

Aqua Control, Inc. — 5