Dexter Laundry KC-39 Series Gebruikershandleiding - Pagina 16
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dexter Laundry KC-39 Series. Dexter Laundry KC-39 Series 17 pagina's.
Pagina afdrukken
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and
dangerous operation. Verify proper operation after servicing.
ATTENTION. Lors des opérations d'entretien des commandes, étiqueter tous les fils avant de les déconnecter.
Toute erreur de câblage peut être une source de danger et de panne.
If any of the following symptoms occur on this dryer, check the suggested remedies listed below. If all probable
causes have been eliminated and the symptom still exists, contact your local Dexter agent for further
troubleshooting assistance. See contact information in Preventative Maintenance section. Parts & Service Manuals
from Dexter are also available for further troubleshooting assistance.
Symptom
Tumbler Does not turn
Tumbler Turns, but no
burner flame is present
Slow Drying
F1 or F2 Fault Code
displayed on control
F3, F4, F5 Fault Code
displayed on control
SERVICING AND TROUBLESHOOTING
Probable Cause
Control
Loading Door
Lint Compartment Door
Drive Belts
Gas shut-off valve
Ignition Module
Control
Lint Screen
Air flow Restrictions/
Make-up Air
Exhaust
Temperature Sensor
Control Error
Suggested Remedy
Check that Control Display shows time available for
drying. If not, deposit money as needed.
Check that Loading Door is completely closed
Check that Lint Compartment Door is completely closed.
Check drive belts for excessive wear. Replace as needed.
Make sure gas shut-off valve is in the open position
Follow the procedure for checking the ignition cycle
listed in Dryer Ignition section of this manual.
Check that proper Temperature setting is chosen.
Clean Lint Screen
Follow installation guidelines for static back pressure and
make-up air
Check exhaust for obstructions, follow installation
guidelines
Contact Dexter agent for assistance
Cycle power to dryer to clear Fault Code or Contact
Dexter Agent for Assistance
- -
16