A.H. Systems 2380 Gebruikershandleiding - Pagina 9

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} A.H. Systems 2380. A.H. Systems 2380 14 pagina's.

A.H. Systems Model Active Monopole Antennas

Active Monopole Calibration

The antenna factor for the rod antenna shall be determined by measuring the signal transfer

characteristics with the matching device and assuming that the antenna is a short monopole with an

infinite ground plane. Set up the monopole to be calibrated and the test equipment per Figure 3.

Allow all equipment to warm up for 30 minutes.

1) With the equipment connected as shown in Figure 1, measure the drive signal voltage V

dBV at the T-connector (A).

2) Leaving the RF output of the signal generator unchanged, transfer the 50  termination to

the T-connector (A) and transfer the receiver input cable to the signal output port (B).

Measure the output signal voltage V

3) The antenna factor (in dB) is calculated by the following equation.

NOTES – If the VSWR of the receiver or signal generator is low, pads (attenuators) may not be

needed or reduced to 6dB or 3dB. The signal generator does not need to be calibrated, but it shall

be stable per manufacturers recommendations. The 50  termination and attenuators shall have

low VSWR. The spectrum analyzer shall be calibrated and have low VSWR.

REV E

Figure 1

Figure 2

in dBV.

AF(dB) = V

– V

– (20*Log(h

* Also referred to as a Dummy Antenna.

))

Eq.3