Aqua Creek Products F-802SC2 Handmatig - Pagina 9
Blader online of download pdf Handmatig voor {categorie_naam} Aqua Creek Products F-802SC2. Aqua Creek Products F-802SC2 16 pagina's. Lift graph
Ook voor Aqua Creek Products F-802SC2: Handmatig (2 pagina's), Snelstarthandleiding (4 pagina's)
Pagina afdrukken- 1. Page Description
- 1. Anchor Installation: Core-Drill Retro-Fit
- 1. Anchor Installation: Saw-Cut Retro-Fit
- 1. Scout 2 Lift Assembly Instructions
- 1. 6 Actuator
- 2. 2 Scout 2 Components
- 2. Table of Contents
- 2. 24 V Battery
- 2. Battery Test Cable Instructions
- 2. Proper Care of Pool & Spa Lifts
- 2. Scout 2 Parts List
- 2. Seat Assembly Parts List
Scout 2 Assembly Instructions (cont.)
6.
The CHAIR ASSEMBLY will arrive attached to the CHAIR ARM adjusted to its highest position.
To adjust the CHAIR ASSEMBLY to a lower position remove the hardware as shown in FIGURE G.
Slide the SEAT ASSEMBLY to its desired position (in 4" increments) and reinstall the hardware. The
maximum adjustment is 16".
DO NOT ATTACH THE CHAIR ASSEMBLY ANY LOWER THAN THE BOTTOM TWO HOLES – ALWAYS USE
THE TWO (2) SUPPLIED HEX BOLTS TO ATTACH THE CHAIR ASSEMBLY TO THE CHAIR ARM!
NOTE: For most applications the seat will be installed in its lowest position. For applications where a
wall or curb must be cleared the seat should be installed in a higher position. In its highest position,
the seat will clear a 11" [279mm] high wall with a footrest and a 26" [660mm] high wall with a legrest.
CHAIR ARM
ADJUSTMENT
HOLES IN 4"
INCREMENTS
(16" ADJ. RANGE)
CHAIR ADJUSTED
TO LOWEST
POSITION
Copyright © 2017 Aqua Creek Products All Rights Reserved
3/8" X 2-1/2"
3/8" FLAT
HEX BOLT
WASHER
5/16" X 3-1/2"
HEX BOLT
5/16" FLAT
WASHER
3/8" FLAT
WASHER
3/8" NYLOCK
NUT
5/16" NYLOCK
NUT
5/16" FLAT
WASHER
FIGURE G
9
Revised 5/9/17