AB Amps 6600A Beknopte handleiding

Blader online of download pdf Beknopte handleiding voor {categorie_naam} AB Amps 6600A. AB Amps 6600A 4 pagina's. Six channel amplifier

The Amplified Design International Professional

Series Model 6600A is a six channel full

featured Amplifier. This compact instrument

(four rack unit) is equipped with three individual

power supplies, six independent balanced and

unbalanced inputs, detent level controls, signal

presence and "Soft Clip" indication, dual

temperature activated fan assist, Stereo/Bridge

switches per each two channels. The 6600A

delivers 400 Watts into 8 Ohms, 600 Watts into

4 Ohms and 750 Watts into 2 Ohms all six

channels driven from 20Hz to 20kHz at less than

.1% distortion (typically 0.01%). Model 6600A

incorporates a three-year, Five Star protection

plan featuring the following unprecedented

circuitry. VI energy limiters are incorporated for

short circuit protection. If an extreme low

impedance exists on any channel, a current

sensing circuit will reduce the output to prevent

amplifier overdrive.

MODEL 6600A

SIX CHANNEL

AMPLIFIER

If an abnormally high AC line voltage is present

or an excessive voltage surge appears, the

amplifier will detect the situation and turn itself

off. If an unlikely DC situation occurs, DC

sensing circuits will trigger the amplifier channel

and turn off. Thermal sensors are installed in

each channel to protect against an over

temperature condition. "Soft Clip" circuitry has

been incorporated for added protection to

prevent hard clipping from improper use. A rear

panel selectable 80Hz Linkwitz Riley fourth

order Lo-Pass filter switch has been added to

channel six for subwoofer applications. Other

features included are internal selectable input

sensitivity, ground lift switch and fully modular

design for service accessibility. Remote turn on

is available as an option. The Model 6600A will

operate from 100/240V 50-60Hz AC Mains and

measures 7" high (four rack unit), 19" wide and

16 1/2" deep.