Aqua Creek Products SPA LIFT ULTRA Handmatig - Pagina 4
Blader online of download pdf Handmatig voor {categorie_naam} Aqua Creek Products SPA LIFT ULTRA. Aqua Creek Products SPA LIFT ULTRA 11 pagina's.
Ook voor Aqua Creek Products SPA LIFT ULTRA: Gebruiksaanwijzing (12 pagina's), Handmatig (12 pagina's)
Pagina afdrukken
Spa Lift Ultra Installation and Assembly
1. Once the anchor inserts have been installed, the base weldment can now be secured to the deck using the 1/2
inch hex bolts and fl at washers. See FIGURE 2.
2. Attach the mast assembly to the base, as shown in FIGURE 3, using
the 1/4 inch nylock nuts and fl at washers. This may require two people.
SPA LIFT ELITE
BASE WELDMENT
1/2" X 1 1/2"
HEX BOLT (3)
1/2" FLAT
WASHER (3)
1" X 8" ANCHOR
INSERT (3)
3. Attach the lifting arm (identifi ed by the two actuator mounting tabs opposed to the control arm which has
no tabs) to the mast assembly using the 1/2 inch shoulder bolt and 3/8 inch nylock and fl at washer. Be sure the
actuator mounting tabs on the lifting arm are facing downward. See FIGURE 4.
4. After the lifting arm is secured to the mast, attach the actuator to the mast and the lifting arm with the 3/8 inch
shoulder bolts and 5/16 inch nylocks and fl at washers as shown in FIGURE 5. Make sure the actuator head faces
the opposite direction of the control box. If rotated the other way, the actuator head might hit the mast.
LIFTING ARM
ACTUATOR
MOUNTING
TABS
3/8" FLAT WASHER
3/8" NYLOCK
MAST ASSEMBLY
FIGURE 4
Copyright © 2016 Aqua Creek Products All Rights Reserved
FIGURE 2
1/2" X 3"
SHOULDER BOLT
LOWER ATTACHMENT
POINT
BASE WELDMENT
5/16" FLAT WASHER
5/16" NYLOCK
ACTUATOR
5/16" FLAT WASHER
5/16" NYLOCK
FIGURE 5
MAST ASSEMBLY
1/4" FLAT
WASHER (4)
1/4" NYLOCK
NUT (4)
FIGURE 3
LIFTING ARM
3/8" X 2"
SHOULDER BOLT
MAST ASSEMBLY
3/8" X 1 1/4"
SHOULDER BOLT
4
Revised 1/29/16