Aqua Flo AQUV AQUV-8R12 Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Aqua Flo AQUV AQUV-8R12. Aqua Flo AQUV AQUV-8R12 16 pagina's. Ultraviolet disinfection system

Pagina afdrukken

Installing the AQUV Rack System

1. There are two mounting holes on the mounting bracket.

Both of them should be mounted directly on to a

wall stud with appropriate screws to carry the weight of

the unit. Included mounting hardware only works for

studs, they are lag bolts and a hole will need to be drilled

to put them in without cracking the stud.

WARNING!

Do not mount the unit directly on drywall

without appropriate reinforcement

2. Install new plumbing using (Fig 2) as reference of how

the final installation should look.

3. Unscrew the filter sump and remove the sanitary wrap from

the filter cartridges. Reinsert the new cartridge into the

sump and screw the sump back onto the filter. Hand-tighten

only.

CAUTION!

DO NOT USE WRENCH TO TIGHTEN SUMP.

4. Carefully unpack UV lamp and quartz dome. Two o-rings

come with the quartz dome. The thinner o-ring is

installed in the groove of the gland nut.

NOTE

Hold lamp and dome by the ends with

soft, dry gloves or cloth. lamp needs to stay

perfectly clean, any dirt or fingerprints on the

lamp will reduce the life.

5. Gently slide the dome O-ring (thicker) over the top (open end)

of the quartz dome to about 1" from the open end (Fig 4).

6. Gently insert the quartz dome into the gland nut and

gently rotate the dome while pushing in until it goes past

the nut O-ring and touches the inside top end of the

gland nut. (Fig 5).

7. Carefully slide the quartz dome with gland nut attached

into the opening at the top of the UV chamber

(Fig 6A & 6B) and hand-tighten the gland nut into place.

CAUTION!

Do not overtighten the gland nut as it can

break the quartz dome.

Broken quartz domes are not covered

under warranty.

8. Slowly open supply-valve and valves before and after UV

system. Check for leaks. Do not proceed to next step

until leaks are fixed.

NOTE

Sediment

Pre-Filter

Drain Port

(Recommended)

Dome O-Ring

Gland Nut

Quartz Dome

TIP: Rotate dome while pushing in

CORRECT

Quartz dome is past gland

nut O-ring and is touching the

inside top end of the gland

nut. Caution: Do not push

hard as it can break the quartz

dome.

Fig.6A

NOTE

Do not use pipe dope or tape on these top

threads before attaching gland nut.

SIDE VIEW

Quartz Dome

Thinner O-Ring

Quartz

Dome STOP

position

Thicker O-Ring

WRONG

Quartz dome is NOT past

gland nut O-ring and is NOT

TOUCHING the inside top end

of the gland nut.

Fig.5

Fig.4

Fig.6B