aqua greek products F-MTY400 Handmatig - Pagina 5
Blader online of download pdf Handmatig voor {categorie_naam} aqua greek products F-MTY400. aqua greek products F-MTY400 13 pagina's.
CORE-DRILL RETRO FIT
CATALOG NO. F-808SA-10
NOTE: YOUR LOCAL CODES MAY REQUIRE ONE OR MORE PERMITS. CHECK WITH YOUR
LOCAL BUILDING CODES FOR THE PROPER PERMIT REQUIREMENTS.
TOOLS REQUIRED:
CORE DRILL, MARKING PEN, 3" CORE DRILL BIT, AIR NOZZLE & PUMP/COMP., 1 1/2"
CORE DRILL BIT, HEAT GUN (OPTIONAL), EPOXY (ANCHOR ADHESIVE), MASKING TAPE
1. Mark the center of the anchor location on your deck using the guidelines on page 3. Also mark
the center for the fixing anchor 3 1/2" from the center anchor.
2. Using a 3" diameter core-drill bit, drill a 3" diameter hole at the anchor location. Make sure to
keep the bit square to the deck. Drill straight down to a depth of at least 6 1/2". Then use a 1 1/2"
drill bit for the fixing anchor, drilling down at least 6"
NOTE: Create a depth marker on the drill bit with black electrical tape to make sure you
drill to the right depth.
If you drill through the deck you may need to use the saw-cut installation instructions.
3. Remove plug and clean out the holes with a wire brush. Insert an air nozzle to the bottom of the
hole. Use a pump or compressed air to blow out the hole. A heat-gun may be helpful in drying out
the hole.
4. Place the anchor in the hole and 'dry-fit' it first to make sure the anchor will be flush and plumb
with the finished deck surface when installed. Adjust the hole as needed.
5. Inject epoxy adhesive into each hole starting at the bottom until the hole is 1/3 to 1/2 full.
NOTE: We recommend using masking tape around the top of the anchors so that no epoxy
gets inside the anchors.
6. Install the anchor into the epoxy filled hole by pushing down and twisting back and forth to
evenly distribute the epoxy around the anchor. Push down until it is flush with the finished deck
surface. Clean off any excess epoxy. Adjust the anchor as needed to make sure it is flush and plumb
with the deck surface. This should be done during the adhesives' specified 'gel time' (see epoxy
manufacturers' instructions).
7. Let the epoxy cure for at least 24 hours before installing the lift (or where applicable according to
the epoxy manufacturers' instructions).
7/12/2022 11:05:06 AM PAGE - 5