Avocent SwitchView Snelle installatiehandleiding - Pagina 2
Blader online of download pdf Snelle installatiehandleiding voor {categorie_naam} Avocent SwitchView. Avocent SwitchView 8 pagina's. Kvm switching solutions from your desktop
Ook voor Avocent SwitchView: Installatie-/gebruikershandleiding (17 pagina's), Gebruikershandleiding (17 pagina's), Specificaties (4 pagina's), Snelle installatiehandleiding (2 pagina's)
Pagina afdrukken
The following instructions will help you
connect your SwitchView unit.
Should you require further assistance, please
contact Avocent Technical Support.
NOTE: All drivers necessary for the SwitchView
are built into the unit. If you are installing the unit
with a Windows operating system and are
prompted for drivers, press NEXT until the
configuration is complete.
1
Powering the SwitchView unit
Power down all computers that will be attached to your
SwitchView unit. Plug the supplied power cord into the
power socket on the rear of the SwitchView unit. Plug
the other end into an appropriate AC power source.
2
Connecting the peripheral devices
Plug your VGA monitor into the port labeled CONSOLE
on the back of the SwitchView. Speakers and a
microphone can be attached using the speaker and
microphone jacks labeled CONSOLE on the back of
the unit. Plug your USB keyboard and mouse into the
labeled ports on the front of the unit.
3
Connecting the first computer
Locate a KVM connection cable. Attach one end to
the monitor, USB, audio in and microphone ports on
the first computer to be attached to the SwitchView.
Route the other end to the SwitchView and attach it
to the 15-pin HDD, speaker and microphone ports.
The USB port sets are labeled PC1-PC4 to correspond
Check our web site at www.avocent.com/support to search the knowledge base or use the on-line service request. Click on Contact Details for regional support.
Quick Installation Guide
SwitchView USB
To connect a SwitchView USB
5
Attach USB devices
to the rear ports of
the SwitchView unit.
1
Power down your
computers and attach
the appropriate
power cord.
2
Plug in the monitor,
followed by the
keyboard and mouse.
with the channels on the unit. The corresponding
speaker and microphone jack sets are labeled 1-4.
4
Connecting the remaining computers
Repeat step 3 to connect additional computers.
5
Connecting USB devices
Plug any USB devices or peripherals into the SwitchView
using the USB ports on the rear of the unit.
2
DC 12V, 1A
2
1
CONSOLE
C
PC4
CONSOLE
UPGRADE
3
Connect the first
computer to the
SwitchView unit.
6
Powering the SwitchView unit and
attached computers
Power the SwitchView. Next to each port is a blue
LED. A blinking LED indicates that the attached
computer is not powered.
Power the first attached computer. Wait until it
has completely booted before switching to the
next computer and repeating the process.
The Power of Being There
6
Power up the
SwitchView unit
and all attached
computers.
4
4
3
3
2
2
1
1
PC3
PC2
PC1
4
Plug in the remaining
computers to the
SwitchView unit.