COZY VC502A-H and Handleiding voor installatie en gebruik - Pagina 14
Blader online of download pdf Handleiding voor installatie en gebruik voor {categorie_naam} COZY VC502A-H and. COZY VC502A-H and 19 pagina's. Gas-fired vented room heater
Ook voor COZY VC502A-H and: Handleiding voor installatie en gebruik (18 pagina's), Handleiding voor installatie en gebruik (18 pagina's)
Pagina afdrukken
TSK WALL
STAT
KIT
OPTIONAL
(VC/VCR-H
SERIES
HEATERS)
WALL THERMOSTAT
INSTALLATION
INSTRUCTIONS
Your heater can be re-wired to operate with a millivolt wall thermostat by your installer. See wiring diagram
below for correct wiring.
NOTE: Do not disconnect the wire from the blocked flue switch to the "TH" terminal on the gas valve.
STEP
1.
STEP 2.
STEP 3.
STEP 4.
STEP5.
Disconnect wire leading from Part #70080 (Bulb Control Switch) from valve.
Cut the remaining wire leading from Part #70080 (Bulb Control Switch) to the blocked flue
switch, leaving its end connected to the blocked flue switch and leaving enough length to reach
the gas valve. Strip 1/2" of the insulation from the cut end of the wire.
Connect one leg of thermostat wire to the "TH/PP" terminal on the gas valve.
Connect second leg from the thermostat to the stripped wire coming from the blocked flue
switch. Secure this connection inside the heater cabinet.
Secure both red wires from blocked flue switch inside heater cabinet. Make sure none of the
wires have enough slack to lay against the heat exchanger or draft hood.
BLOCKED
FLUE SWITCH
THERMOSTAT
OPTIONAL
WIRE
NUT
PILOT
GENERATOR
Page 14