Aqua Lung Conshelf XIV Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Aqua Lung Conshelf XIV. Aqua Lung Conshelf XIV 20 pagina's.

PREPARATION AND SET UP

Aqua Lung America, Inc. requires that only an Authorized Aqua Lung Technician

install any accessory items such as instrumentation, MP inflator hose, alternate

air source, DIN connector or FCD to the regulator.

1. Partially loosen the yoke screw on the first stage regulator so that the dust

cap can be removed from the air inlet.

2. Remove the protector cap from the cylinder valve.

3. With the cylinder valve facing away from you, release a small amount of air

from the cylinder by turning the handwheel counter-clockwise to open the valve

only slightly. When air is heard exiting, immediately close the valve. This will

clear any moisture or debris that may be inside the cylinder valve outlet opening.

4. Check the condition of the cylinder valve o-ring.

5. Place the first stage regulator over the cylinder valve so that the inlet fitting

aligns with the o-ring of the cylinder valve and the MP hose of the primary

second stage will be routed over the right shoulder. While holding the first

stage in place, turn the yoke screw clockwise. Ensure that the yoke screw

mates into the small dimple on the backside of the cylinder valve and tighten

until finger tight (Fig. 2).

Figure 2