DF ROBOT LeoYan Handmatig - Pagina 13

Blader online of download pdf Handmatig voor {categorie_naam} DF ROBOT LeoYan. DF ROBOT LeoYan 20 pagina's.

1.4 横架安装 Assemble the Bar

将 DHT22 温湿度传感器如图用螺丝固定在横架上：

Fix the DHT22 temperature & humidity sensor on the bar with screws as it's shown in the photo

below.

1.5 侧板安装

Assemble the Side Plate

将螺母放入侧板底部的十字槽中，其中两个螺母将用于最后组装时连接背板。（实际组装时

只用靠近背板的两个螺母，这里全部装上，是为了整体组装时方便）

Place nuts into cross-slots at the bottom of the side plate. Two of the nuts will be used to connect

it with the rear plate. (Practically, we will only used the two nuts close to the rear plate. Here we

slide them all into the slots to make things easy for the overall installation.)

1.6 整体组装 Overall Installation

按下图将各模块连接；连接好后点击前面板的触摸模块，若有内容显示则正常，否则检

查接线。

Follow the map below and connect the modules. Once connected click the touch module on

the front plate and check if information is displayed properly on it. If not, check the cable

connections.

CNP a g e

| 13