Allied 4SHP16 Handleiding voor installatie-instructies

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Allied 4SHP16. Allied 4SHP16 19 pagina's. Single stage heat pump

Pagina afdrukken
4SHP16 Single Stage Heat Pump
This is a safety alert symbol and should never be ignored. When you see this symbol on labels or in
manuals, be alert to the potential for personal injury or death.

Table of Contents

Safety Precautions ......................................................2
Installation ...................................................................2
Leak Test and Evacuation ...........................................7
Start-Up Procedure....................................................12
Operation ...................................................................13
Homeowner's Information .........................................18
Installation or repairs made by unqualified persons can
result in hazards to you and others. Installation MUST
conform with local building codes and with the National
Electrical Code NFPA 70/ANSI C1-1993 or current
edition and Canadian Electrical Code Part 1 CSA C22.1.
Improper installation, adjustment, alteration, service
or maintenance will void the warranty. The qualified
installer or agency must use factory-authorized kits
or accessories when added to this products. Refer to
the individual instructions included with the specific
accessory kit.
Manufactured By
Allied Air Enterprises LLC
A Lennox International, Inc. Company
215 Metropolitan Drive
West Columbia, SC 29170
507919-01F
INSTALLATION INSTRUCTIONS
(R410A REFRIGERANT)
This manual must be left with the homeowner for future reference.
CAUTION
Save these instructions for future reference
These instructions are intended as a general guide and
do not supersede national, state or local codes in any
way.
NOTE TO INSTALLING DEALER
These instructions and warranty are to be given to the
owner or displayed near the indoor air handler unit.
Failure to follow instructions will cause damage to the
unit.
This unit is equipped with an aluminum coil. Aluminum
coils may be damaged by exposure to solutions with
a pH below 5 or above 9. The aluminum coil should
be cleaned using potable water at a moderate pressure
(less than 50psi). If the coil cannot be cleaned using
water alone, it is recommended to use a coil cleaner
with a pH in the range of 5 to 9. The coil must be rinsed
thoroughly after cleaning.
In coastal areas, the coil should be cleaned with potable
water several times per year to avoid corrosive buildup
(salt).
*P507919-01F*
Issue 1846
NOTICE
NOTICE
(P) 507919-01F
Page 1 of 19