Aqua Lung Enforcer Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Aqua Lung Enforcer. Aqua Lung Enforcer 20 pagina's.

REPAIR - LOCATING A LEAK

For repair of major leaks and/or tears, it is advisable to send your drywear to an

authorized regional repair center. However, there are times when some basic minor

repairs can be done. What is required: mild soap, water container, pump (air mattress

pump), twine, and chalk.

1. Wrap the wrist seals and tie snug with twine.

2. Gather neckseal around hose from hand pump and tie snug with twine.

3. Pump up drywear until fully inflated.

4. With drywear inflated, pour soapy water over suspected leak areas. Mark areas

where bubbles appear with chalk.

REPAIRING A HOLE IN A WATERPROOF BREATHABLE MATERIAL

1. Turn your drywear inside out. Make sure it is clean and dry. Place a flat hard object

(like a block) inside your drywear, directly under the hole. The block helps support the

material during the repair process. TIP: Stretch an elastic band around the material and

block to help hold the material in place.

2. Cut heat activated repair patches to size (the repair system requires two separate

heat activated patches to be applied in sequence).

i) Cut the base patch about 1/8" (3mm) larger all the way around than the top patch.

Identify the 2 different patch materials: The base layer patch (A) has a clear film

laminated onto white paper backing. The top patch (B) has a smooth black finish on

one side and a matte grey finish on the other.

ii) Cut patches to extend at about ½" past the edges of the hole on all sides.

Rounding the corners of the patch will make a clean edge finish.

REPAIRS

ENGLISH