Avolites Titan Net Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Avolites Titan Net. Avolites Titan Net 15 pagina's.

Pagina afdrukken
Status display - Page 8

6. STATUS DISPLAY

In normal operation the TNS displays the following status display:
TNS 0059
IP1
10.0.0.100
IP2
10.0.0.101
Switch connected
The top line shows the name of the TNS as it will show up for discovery on the
network. This can be set by the user in the menu options.
IP1 is the IP address of the network switch. This is user configurable (see 6.1)
IP2 is the IP address for the control panel which is used to configure the switch. IP2 is
automatically set to be one address above IP1 on the same subnet.
Note: You must keep both of these IP addresses free in your network to ensure
correct operation of the TNS.
The bottom line shows the status of the network.
If no network is detected on any port, the display will show
TNS 0059
IP1
10.0.0.100
IP2
10.0.0.101
Checking connection
then
Interface reboot 5
IP1
10.0.0.100
IP2
10.0.0.101
..until connected
The number top right will count down to zero and the unit will cycle in this state until a
functioning network is connected to the TNS.
6.1

ETHERNET PORT STATUS INDICATIONS

The etherCON ports have indicator lights which show the status of the ports.
Left: Power over Ethernet status
Off
Red
Flash red
Titan Network Switch v1a.doc 29 March 2022
PoE not active
PoE active
PoE overload status