Bilberry Stoves 8kW Stove Handleiding voor installatie en gebruik - Pagina 3
Blader online of download pdf Handleiding voor installatie en gebruik voor {categorie_naam} Bilberry Stoves 8kW Stove. Bilberry Stoves 8kW Stove 20 pagina's.
Pagina afdrukken
PRE-INSTALLATION CHECKS
Installation of a stove must be done according to local codes and regulations. National and European standards
must be observed when installing this product.
Please read the Installation & Operation manual enclosed with this product before use.
TECHNICAL DATA
Material:
Finish:
Fuel:
Log Length - Max.:
Flue Outlet:
Flue Pipe Dimension- ID:-
Weight [Approx.]:
Dimensions:
Nominal Heat Output:
Recommended Chimney
Draught:
Operational Mode:
* Note: Intermittent combustion in this context means normal use of the stove, i.e. fuel is added as soon as
the fuel has burned down.
Unpacking The Stove
After removing the outer packaging, unbolt the combustion chamber from the wooden pallet and place it gently
on its back. The cardboard packaging can be placed underneath to prevent damaging the stove. Remove the
leg pack from the stove and bolt each leg securely to the underside of the base on the combustion chamber,
using the bolts provided (these can be found inside the stove).
We recommend that two people perform the assembly and installation procedure.
Installing The Stove
The stove and chimney installations MUST comply with current National & Local Building Regulations; your
approved dealer or your local building officer can advise regarding this. Ultimately, it is you and your installer
who is responsible that the installation complies.
Floor Protection
If installing this stove on a combustible floor, floor protection must be provided, consisting of a layer of noncom-
bustible insulation material 10mm thick. This insulation can then be covered with 3mm sheet metal. This insu-
lation material should extend past the sides and front of the stove, 400mm to front and 200mm to the sides.
BILBERRY SOLID FUEL STOVES
INSTALLATION INSTRUCTIONS
5kW Stove
Cast Iron
High Temp Resistant Paint
Solid Fuel
32 cm
Top & Rear
125mm
70kgs
W 400 x H 553 x D 383
5kW
0.06" w.g. min.
* Intermittent
INSTALLATION
3
8kW Stove
Cast Iron
High Temp Resistant
Paint
Solid Fuel
35 cm
Top & Rear
125mm
80kgs
W 457 x H 583 x D 426
8kW
0.06" w.g. min.
* Intermittent
10kW Stove
Cast Iron
High Temp Resistant Paint
Solid Fuel
41 cm
Top & Rear
150mm
148kgs
W 583 x H 634 x D 482
10kW
0.06" w.g. min.
* Intermittent