Billi B–1000 Installatiehandleiding - Pagina 2
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Billi B–1000. Billi B–1000 2 pagina's. Instant filtered water system
Pagina afdrukkenInstallation
instructions.
1. Connect the pressure limiting valve (with
blue mini-tap ) to the mains water supply.
2. Connect one end of the white hose
provided to the blue mini-tap and connect
the other end of the white hose to the
Filter Module fitting labeled "IN".
3. Mount the Filter Module in an easily
accessible position, preferably close
to the front of the cupboard to allow
for filter changes.
Billi Pty Ltd
42 Lucknow Crescent, Thomastown
Victoria 3074 Australia
Telephone +61 3 9469 0400
Facsimile +61 3 9469 0499
www.billihome.com.au
4. After establishing where the dispenser
can be installed (within the limits of the
hose length from the dispenser to Filter
Module), punch a 22mm hole for mounting
the dispenser.
5. Mount the dispenser by first passing
the blue hose through the hole and then
fitting the locking bush and lock nut to the
threaded mounting shaft (see Diagram 1).
Tighten the locknut. Reconnect blue hose
to the out fitting.
Designed and manufactured in Australia.
As Billi Pty Ltd has a policy of continual
improvement, all details are subject
to change without notice. All goods
are sold subject to our published terms
and conditions. Billi is a registered
trademark. 0911
6. Turn on the mains tap and then turn
on the blue mini-tap and check for leaks.
If no leaks are detected, rotate the lever
on the dispenser until a good stream of
water is present.
Note: There may be air bubbles in the water
at first as the water filter is dry. Allow 2-3
minutes of continuous run to ensure all air
bubbles have been flushed from the system.
Billi B-1000
Instant Filtered
Water System